Related Experiment Video

Updated: Mar 30, 2026

Capturing Actively Produced Microbial Volatile Organic Compounds from Human-Associated Samples with Vacuum-Assisted Sorbent Extraction
09:19

Capturing Actively Produced Microbial Volatile Organic Compounds from Human-Associated Samples with Vacuum-Assisted Sorbent Extraction

Published on: June 1, 2022

4.7K

Concentrations of Volatile Organic Compound (Styrene) in an Industrial Area of Agra, India

Anu Chandra, Deepti Srivastava, Ashok Kumar

    Journal of Environmental Science & Engineering
    |November 14, 2015
    PubMed

    More Related Videos

    Visualizing Field Data Collection Procedures of Exposure and Biomarker Assessments for the Household Air Pollution Intervention Network Trial in India09:33

    Visualizing Field Data Collection Procedures of Exposure and Biomarker Assessments for the Household Air Pollution Intervention Network Trial in India

    Published on: December 23, 2022

    3.1K
    Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers07:12

    Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers

    Published on: December 12, 2025

    299

    Related Concept Videos

    Stress Concentrations01:13

    Stress Concentrations

    The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
    The stress...
    765
    Stress Concentrations01:24

    Stress Concentrations

    Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
    816
    Volatilization01:10

    Volatilization

    Volatilization gravimetry is an analytical technique that measures the mass lost due to the volatilization of the substance. This technique is used to estimate the amount of volatile material in a sample. To perform this method, heat a known amount of the sample to a high temperature in a crucible or other suitable vessel. The volatile substance in the sample evaporates, and the vapor is completely expelled from the crucible either by heating the sample or bubbling a stream of inert gas through...
    6.4K
    Deleterious Substances in Aggregate01:25

    Deleterious Substances in Aggregate

    Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
    Another type of impurity is clay and fine material that...
    706
    Effects of Chemicals: Overview01:27

    Effects of Chemicals: Overview

    Drugs, encompassing various chemical compounds from natural sources, lab synthesis, or genetic engineering, elicit different biological responses in living organisms. Some of these responses are desirable or therapeutic, while others are undesirable. The primary goal of administering a drug is to achieve a therapeutic effect, that is, to address a specific disease or health condition. Any concurrent effects outside of this therapeutic outcome are considered undesirable. These undesirable...
    2.4K
    Plasticizers01:31

    Plasticizers

    Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
    Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
    457