[Comparative Study for Anti-Hepatitis B Surface Antigen Titers Based on Two Measurement Methods: Using Monoclonal...

As anti-hepatitis B surface antigen (anti-HBs) titers vary depending on the measurement methods, we compared two different methods to measure anti-HBs titers in sera and HBs monoclonal antibodies.

The sera from 182 HB virus-resolved patients who were negative for HBsAg but positive for antiHB core protein (HBc) and/or anti-HBs were obtained. The measurement of anti-HBs was compared using either Lumipulse G1200 or Architect i2000SR. Six different monoclonal antibody (mAbs) clones isolated from healthy individuals inoculated with hepatitis B vaccine Bimmugen (genotype C) were used.

A statistically significant correlation in anti-HBs titers was found between the two methods tested (Y = 0.951X + 100.7, R = 0.813, p < 0.001), although anti-HBs titers in 72 samples (39.6%) measured by Architect were less than 50% of that by Lumipulse and 12 (6.6%) were opposite results. Measuring 2 mAbs with HBV neutralizing activity, the titers of the 116 antibody (1.0 μg/mL) were comparable (689.3 mIU/mL by Lumipulse and 440.7 mIU/mL by Architect), whereas those of the 478 antibody (1.0 μg/mL) were much lower by Architect than by Lumipulse (42.6 vs. 818.6 mIU/mL, respectively). Of four other mAbs without HBV neutralizing activity, equal titers were observed for one; two mAbs had less anti-HB titers by Architect; and one was below the cut-off index (< 5 mIU/mL).

Anti-HBs titers measured by Architect are likely to be lower than by Lumipulse, and the potential ability to detect the 478 antibody with neutralizing activity is low, indicating that Architect might underestimate anti-HBs titers. Future studies should standardize the anti-HBs titer measurement system.