A system to reproduce and quantify the biomechanical environment of the cell

An in vitro system that permits application of a uniform biomechanical stimulus to a population of cells with great precision has been developed. The device is designed to subject living cells to reproducible and quantifiable biaxial strains from 0 to 10% at rates from quasi-static to 1 s-1 and frequencies from 0 to 5 Hz. Equations for determining the strain in the substrate upon which the cells are grown, based on easily measured parameters, are derived and validated experimentally. The mechanical properties of the substrate are determined, and it is demonstrated that cells can easily be cultured in the apparatus. By use of the system, cloned bovine pulmonary artery endothelial cell clones are subjected to 5% biaxial strains applied at a peak strain rate of 0.5 s-1 and a frequency of 1 Hz for 7 h with cell viability greater than 84% and cell detachment less than 8%. We demonstrate that cells must be attached to the substrate for them to be stretched and that cell strain and substrate strain are not equal. With the use of fluorescently labeled beads as cell surface markers to measure the actual strain produced in the cells as a result of the deformation of the substrate, cell elongation was found to be approximately 60% of the strain in the substrate. This constant appeared to be affected by both in vitro cell age and morphology.