Related Experiment Video
Updated: Mar 27, 2026

Experimental Column Setup for Studying Anaerobic Biogeochemical Interactions Between Iron OxyHydroxides, Trace Elements, and Bacteria
Published on: December 19, 2017
Strong Acid Mixture and Sequential Geochemical Arsenic Extractions in Surface Sediments from the Santa Maria La
José R Rivera-Hernández1, Carlos Green-Ruiz2
1Posgrado en Ciencias del Mar y Limnología, Universidad Nacional Autónoma de México, Av. Joel Montes Camarena s/n, Col. Playa Sur Col. Playa Sur, 82040, Mazatlán, Sinaloa, Mexico.
Abstract:
Thirty-three sediment samples were collected from the Santa Maria La Reforma coastal lagoon and digested by way of a strong acid mixture and sequential arsenic (As)-extraction method to determine the arsenic (As) content and bioavailability. The As content was determined by atomic fluorescence spectrometry. In addition, grain-size analyses were performed, and organic carbon, carbonate, and iron (Fe) and manganese (Mn) concentrations were determined. Fe and Mn determination was performed by atomic absorption spectroscopy. A Pearson correlation matrix and As enrichment factors were calculated. Sediment concentrations from Santa Maria La Reforma ranged from 3.6 to 25 µg As g(-1) with an average of 13.4 ± 7.6 µg As g(-1). The highest values were observed in the northern (Playa Colorada), north-central (Mocorito River discharge zone), and southern zones ("El Tule" agricultural drain). Most samples were classified as exhibiting no or minor As enrichment and were lower than the threshold effect level (TEL; 7.24 µg g(-1)) for biota (MacDonald et al. in Ecotoxicology 5:253-278, 1996). Low bioavailable As values (<3 %) were measured in the majority of the sediment. The highest As percentages were associated with the oxyhydroxide fraction (F5). The results indicate that As bioavailability is negligible.
More Related Videos
Related Concept Videos
Precipitation and Co-precipitation
Extraction: Advanced Methods
Sample Preparation for Analysis: Advanced Techniques
Acid digestion with strong acids is commonly used to dissolve inorganic materials that are insoluble (do not dissolve) in water. This method can be useful for...
Acid Mine Drainage
Microbial Leaching

