A biomechanical assessment of fixation methods for a coronoid prosthesis
Alia B Gray1, Bashar Alolabi1, Simon Deluce1
1Hand and Upper Limb Centre, University of Western Ontario, St. Joseph's Health Centre, 268 Grosvenor St., London, ON N6A 4L6, Canada.
Background:
The coronoid process is an integral component for maintaining elbow joint stability. When fixation of a fracture is not possible, prosthetic replacement may be a feasible solution for restoring stability. The purpose of this in-vitro biomechanical study was to compare fixation methods for a coronoid implant.
Methods:
A coronoid prosthesis was subjected to distally-directed tip loading after implantation using four fixation methods: press-fit, anterior-to-posterior screws, posterior-to-anterior screws, and cement. Testing was performed on seven fresh-frozen ulnae in a repeated-measures model. Rounds of cyclic loading were applied at 1 Hz, for 100 cycles, increased in 50 N increments up to a maximum of 400 N. Micro-motion of the implant was quantified using an optical-tracking system. Outcome variables included total displacement, distal translation, gapping, anterior translation and axial stem rotation.
Findings:
Cement fixation reduced implant micro-motion compared to screw fixation, while the greatest implant micro-motion was observed in press-fit fixation. Comparing screw-fixation techniques, posterior-anterior screws provided superior stability only in distal translation. The implant did not experience displacements exceeding 0.9 mm with screw or cement fixation.
Interpretation:
Cement fixation provides the best initial fixation for a coronoid implant. However, the stability provided by both methods of screw fixation may be sufficient to allow osseous integration to be achieved for long-term fixation. Large displacements were observed using the press-fit fixation technique, suggesting that modifications would need to be developed and tested before this technique could be recommended for clinical application.
