The place of viscoelastic testing in clinical practice

Gregory A Hans1, Martin W Besser2

  • 1Department of Anaesthesia and Intensive Care Medicine, CHU of Liege, Liege, Belgium.

Hellmut Hartert was the first person to exploit the viscoelastic properties of clotting blood to measure blood coagulation in 1948. Since then, the technology has improved, allowing these analyses to be performed as point-of-care tests with immediately-available results. The addition of several activators and inhibitors to the original assay creates a panel of tests able to quantify the different aspects of blood clotting that can rival conventional laboratory assays. However, although much progress has been made, the standardization and validation of these tests still need improvement. Viscoelastic analyses of blood coagulation are mainly used to guide haemostatic therapy in bleeding patients and have proven superior to standard clotting tests in some circumstances. There is potential to extend their use to other areas, such as drug monitoring, and diagnosis and management of congenital bleeding disorders. The forthcoming cartridge-based assays are expected to improve the reliability and usability of viscoelastic assays of blood coagulation but high quality clinical trials remain urgently needed to determine their exact place, benefit and cost effectiveness.

Related Concept Videos

Strain and Elastic Modulus01:15

Strain and Elastic Modulus

The quantity that describes the deformation of a body under stress is known as strain. Strain is given as a fractional change in either length, volume, or geometry under tensile, volume (also known as bulk), or shear stress, respectively, and is a dimensionless quantity. The strain experienced by a body under tensile or compressive stress is called tensile or compressive strain, respectively. In contrast, the strain experienced under bulk stress and shear stress is known as volume and shear...
9.3K
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...
647
Venous Thrombosis II: Clinical Manifestations and Diagnostic Studies01:20

Venous Thrombosis II: Clinical Manifestations and Diagnostic Studies

The key difference between Superficial Vein Thrombosis (SVT) and Deep Vein Thrombosis (DVT) lies in their location and severity.Clinical ManifestationsSVT typically presents with localized pain, tenderness, and redness along the course of a superficial vein, often accompanied by a palpable, cord-like structure under the skin. This condition is usually less dangerous than DVT but can be uncomfortable and may lead to complications such as cellulitis or, rarely, a clot extension into the deep...
433
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
706