The self-absorption correction factors for ²¹⁰Pb concentration in mining waste and influence on environmental...

The radioactive lead isotope ²¹⁰Pb occurs in waste originating from metal smelting and refining industry, gas and oil extraction and sometimes from underground coal mines, which are deposited in natural environment very often. Radiation risk assessment requires accurate knowledge about the concentration of ²¹⁰Pb in such materials. Laboratory measurements seem to be the only reliable method applicable in environmental ²¹⁰Pb monitoring. One of the methods is gamma-ray spectrometry, which is a very fast and cost-effective method to determine ²¹⁰Pb concentration. On the other hand, the self-attenuation of gamma ray from ²¹⁰Pb (46.5 keV) in a sample is significant as it does not depend only on sample density but also on sample chemical composition (sample matrix). This phenomenon is responsible for the under-estimation of the ²¹⁰Pb activity concentration level often when gamma spectrometry is applied with no regard to relevant corrections. Finally, the corresponding radiation risk can be also improperly evaluated. Sixty samples of coal mining solid tailings (sediments created from underground mining water) were analysed. Slightly modified and adapted to the existing laboratory condition, a transmission method has been applied for the accurate measurement of ²¹⁰Pb concentration . The observed concentrations of ²¹⁰Pb range between 42.2 ÷ 11,700 Bq·kg^-1 of dry mass. Experimentally obtained correction factors related to a sample density and elemental composition range between 1.11 and 6.97. Neglecting this factor can cause a significant error or underestimations in radiological risk assessment. The obtained results have been used for environmental radiation risk assessment performed by use of the ERICA tool assuming exposure conditions typical for the final destination of such kind of waste.