Physicochemical aspects of epoxide driven nano-ZrO2 hydrogel formation: milder kinetics for better properties
V Oestreicher1, M Perullini1, M Jobbágy2
1INQUIMAE, DQIAQF, Facultad de Ciencias Exactas y Naturales, Universidad de Buenos Aires, Pabellón II, Ciudad Universitaria, C1428EHA-Buenos Aires, Argentina. mercedesp@qi.fcen.uba.ar jobbag@qi.fcen.uba.ar.
Abstract:
Robust and highly transparent quasi amorphous ZrO2-water-glycerol hydrogels were obtained in a mild one pot procedure, based on the 2,3-epoxy-1-propanol driven alkalinization. SAXS-based characterization of the sol-gel transition revealed that an homogeneously nucleated sol composed of 2 nm primary particles continuously grows up to a critical size of 5-6 nm, when gelation takes place. These particles reach a size of 8-10 nm, depending on the Zr(iv) concentration. Conductivity measurements offer an overall in situ assessment of the reaction rate. The gelled samples share a common trend: once the conductivity decays to 40% of the starting value, the primary particles nucleate and when this decay reaches 20%, the sol-gel transition takes place. The mild conditions employed herein prevent massive ripening and recrystallization leaving hydrogels with extremely low undesired visible light scattering. This suitable nanostructure was achieved in a wide range of total Zr(iv) concentrations or water to glycerol ratios.
Related Concept Videos
Preparation of Epoxides
Epoxides result from alkene oxidation, which can be achieved by a) air, b) peroxy acids, c) hypochlorous acids, and d) halohydrin cyclization.
Epoxidation with Peroxy Acids
Epoxidation of alkenes via oxidation with peroxy acids involves the conversion of a carbon–carbon double bond to an epoxide using the oxidizing agent meta-chloroperoxybenzoic acid, commonly known as MCPBA. Since the O–O bond of peroxy acids is very weak, the addition of electrophilic oxygen of peroxy acids to...
Acid-Catalyzed Ring-Opening of Epoxides
Base-Catalyzed Ring-Opening of Epoxides


