The predictive distribution of the residual variability in the linear-fixed effects model for clinical cross-over

Anja Bertsche1,2, Gerhard Nehmiz2, Jan Beyersmann1

  • 1Institute of Statistics, Ulm University, Helmholtzstr. 20, 89069 Ulm, Germany.

Related Concept Videos

Crossover Experiments01:16

Crossover Experiments

Crossover experiments, also called the repeated-measurements design, is a study design in which all experimental units are exposed to all treatments in different periods. Crossover experiments are generally used in psychology, the pharmaceutical industry, agriculture, and medicine.
Crossover designs are performed even with smaller sample sizes since the samples can act as their controls. These are better than simple randomized trials since patients are exposed to all the treatments.
4.7K
Residuals and Least-Squares Property01:11

Residuals and Least-Squares Property

The vertical distance between the actual value of y and the estimated value of y. In other words, it measures the vertical distance between the actual data point and the predicted point on the line
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...
9.8K
Residual Plots01:07

Residual Plots

A residual plot is a statistical representation of data used to analyze correlation and regression results. It helps verify the requirements for drawing specific conclusions about correlation and regression. To obtain the residual plot, first, the residual for each data value is calculated, which is simply the vertical distance between the observed and the predicted value obtained from the regression equation.
When the residual values are plotted against the variable x, it is called a residual...
6.7K
Variation01:19

Variation

An important characteristic of any set of data is the variation in the data. In some data sets, the data values are concentrated closely near the mean; in other data sets, the data values are more widely spread out from the mean. The most common measure of variation, or spread, is the standard deviation, which is the square root of variance.
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
8.3K
Bioequivalence Data: Statistical Interpretation01:16

Bioequivalence Data: Statistical Interpretation

The statistical interpretation of bioequivalence data is a significant aspect of pharmaceutical research. Bioequivalence refers to the absence of any significant difference in the rate and extent to which the active ingredient in pharmaceutical products becomes available at the site of drug action when administered at the same molar dose under similar conditions. This helps determine if different drug products have similar absorption rates, ensuring their interchangeability.Statistical...
314
Analysis of Population Pharmacokinetic Data01:12

Analysis of Population Pharmacokinetic Data

Analysis of population pharmacokinetic data involves studying the behavior of drugs within diverse populations to understand their pharmacokinetic parameters. Traditional pharmacokinetic methods typically involve collecting samples from a few individuals and estimating these parameters. While these methods are commonly used, they have limitations in capturing the variability in drug response among individuals or heterogeneous populations. Population pharmacokinetics is employed to address these...
904