Bromide oxidation by ferrate(VI): The formation of active bromine and bromate

Yanjun Jiang1, Joseph E Goodwill2, John E Tobiason1

  • 1Department of Civil and Environmental Engineering, University of Massachusetts, Amherst, MA 01003, United States.

Water Research
|April 7, 2016
PubMed

Related Concept Videos

Electrophilic Aromatic Substitution: Chlorination and Bromination of Benzene01:15

Electrophilic Aromatic Substitution: Chlorination and Bromination of Benzene

Chlorination and bromination are important classes of electrophilic aromatic substitutions, where benzene reacts with chlorine or bromine in the presence of a Lewis acid catalyst to give halogenated substitution products. A Lewis acid such as aluminium chloride or ferric chloride catalyzes the chlorination, and ferric bromide catalyzes the bromination reactions. During the bromination of alkenes, bromine polarizes and becomes electrophilic. However, in the bromination of benzene, the bromine...
12.6K
Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene01:13

Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene

Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.
7.9K
Structure of Benzene: Kekulé Model01:07

Structure of Benzene: Kekulé Model

In 1865, August Kekule suggested the structure of benzene according to the structural theory of organic chemistry based on the three assertions—formula of benzene is C6H6, all the hydrogens of benzene are equivalent, and each carbon must have four bonds due to its tetravalency.
He proposed that benzene has a cyclic structure of six carbon atoms attached to one hydrogen atom each, with three alternating pi bonds.
13.0K
Rate-Determining Steps03:08

Rate-Determining Steps

Relating Reaction Mechanisms
In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.
The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to...
39.2K
Radical Oxidation of Allylic and Benzylic Alcohols01:21

Radical Oxidation of Allylic and Benzylic Alcohols

Activated manganese(IV) oxide can selectively oxidize allylic and benzylic alcohols via a radical intermediate mechanism. Primary allylic alcohols are oxidized to aldehydes, while secondary allylic alcohols yield ketones. The redox reaction of potassium permanganate with an Mn(II) salt such as manganese sulfate (under either alkaline or acidic conditions), followed by thorough drying, yields the oxidizing agent: activated MnO2. While MnO2 is insoluble in the solvents used for the reaction, the...
3.1K
Redox Titration: Other Oxidizing and Reducing Agents01:26

Redox Titration: Other Oxidizing and Reducing Agents

Besides iodine, other oxidizing or reducing agents can serve as titrants in redox titrations. Common oxidizing titrants include KMnO4, cerium(IV), and K2Cr2O7. The choice of oxidizing titrants depends on factors like stability, cost, analyte strength, and reaction rate between the analyte and titrant. KMnO4 is a strong oxidizing titrant that reduces from Mn(VII) to Mn(II) in a highly acidic solution, simultaneously oxidizing the analyte to a higher oxidation state. In this case, KMnO4 acts as a...
1.6K