Studies on the Synthesis of the Alkaloid (-)-Gilbertine via Indolidene Chemistry

Direct alkylation is not a suitable method for synthesizing amines because it produces polyalkylated products. Gabriel synthesis is the most preferred method to exclusively make primary amines. The method uses phthalimide, which contains a protected form of nitrogen that participates in alkylation only once to predominantly give primary amines.
Strong bases like NaOH or KOH deprotonate the phthalimide to form the corresponding anion, which acts as a nucleophile. Further, the anion attacks an...

Direct alkylation of ammonia produces polyalkylated amines, along with a quaternary ammonium salt. To exclusively prepare primary amines, the azide synthesis method can be used.
Azide ions act as good nucleophiles and react with unhindered alkyl halides to form alkyl azides. Alkyl azides do not participate in further nucleophilic substitution reactions, thereby eliminating the chances of polyalkylated products. Alkyl azides are reduced by hydride-based reducing agents, like lithium aluminum...

Lithium dialkyl cuprate, also known as Gilman reagents, selectively reduces acid halides to ketones. The acid chloride is treated with Gilman reagent at −78 °C in the presence of ether solution to produce a ketone in good yield.
As shown below, the mechanism proceeds in two steps. First, one of the alkyl groups of the reagent acts as a nucleophile and attacks the acyl carbon of the acid chloride to form a tetrahedral intermediate. This is followed by the reformation of the carbon–oxygen...

Imine formation involves the addition of carbonyl compounds to a primary amine. It begins with the generation of carbinolamine through a series of steps involving an initial nucleophilic attack and then several proton transfer reactions. The second part includes the elimination of water, as a leaving group, to give the imine.
Imines are formed under mildly acidic conditions. A pH of 4.5 is ideal for the reaction.
If the pH is low or the solution is too acidic, the reaction slows down in the...

Cyanohydrins are compounds that contain –CN and –OH groups on the same carbon atom. They are formed by the nucleophilic addition of the cyanide ions to the carbonyl group. Cyanide ions are highly basic and nucleophilic and can be generated from HCN under aqueous conditions. However, since HCN is a weak acid, the number of cyanide ions generated is very small. Hence, a small amount of base or KCN/NaCN is added to HCN to increase the concentration of the cyanide ions in the reaction...

Introduction
Alkynes can be prepared by dehydrohalogenation of vicinal or geminal dihalides in the presence of a strong base like sodium amide in liquid ammonia. The reaction proceeds with the loss of two equivalents of hydrogen halide (HX) via two successive E2 elimination reactions.