Scaling and universality in glass transition

Antonio de Candia1,2,3, Annalisa Fierro1,2, Antonio Coniglio1,2

  • 1Dipartimento di Fisica "Ettore Pancini", Università di Napoli "Federico II", Complesso Universitario di Monte Sant'Angelo, via Cintia, 80126 Napoli, Italy.

Scientific Reports
|May 26, 2016
PubMed

Related Concept Videos

Entropy Changes Accompanying Specific Processes01:21

Entropy Changes Accompanying Specific Processes

Entropy, a measure of disorder in a system, changes during phase transitions like freezing or boiling. At the transition temperature Ttrs, where two phases are in equilibrium, the phase transition is a reversible process. The entropy change can be calculated from a substance's enthalpy of transition using the equation ΔStrs = ΔtrsH /Ttrs.When a perfect gas expands isothermally from one volume to another, entropy increases logarithmically with volume. Conversely, isothermal compression...
65
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
15.6K
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
695
Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
22.0K
Polymer Classification: Crystallinity01:21

Polymer Classification: Crystallinity

Unlike ionic or small covalent molecules, polymers do not form crystalline solids due to the diffusion limitations of their long-chain structures. However, polymers contain microscopic crystalline domains separated by amorphous domains.
Crystalline domains are the regions where polymer chains are aligned in an orderly manner and held together in proximity by intermolecular forces. For example, chains in the crystalline domains of polyethylene and nylon are bound together by van der Waals...
4.2K
Phase Transitions01:21

Phase Transitions

A phase transition is the process in which a substance changes from one state of matter to another, like from a solid to a liquid, liquid to gas, or vice versa, at a specific temperature and under given pressure conditions. This change is spontaneous and is affected by alterations in temperature and pressure. These parameters impact the strength of the forces between molecules (intermolecular forces) in the substance.During a phase transition, both the initial and final phases of the substance...
43