Related Experiment Video
Updated: Mar 20, 2026

Influence of Hybrid Perovskite Fabrication Methods on Film Formation, Electronic Structure, and Solar Cell Performance
Published on: February 27, 2017
High-temperature single-crystal X-ray diffraction study of tetragonal and cubic perovskite-type PbTiO3 phases
Akira Yoshiasa1, Tomotaka Nakatani1, Akihiko Nakatsuka2
1Graduate School of Science and Technology, Kumamoto University, Kurokami 2-36-1, Kumamoto 860-8555, Japan.
Abstract:
A high-temperature single-crystal X-ray diffraction study of a synthetic PbTiO3 perovskite was carried out over the wide temperature range 298-928 K. A transition from a tetragonal (P4mm) to a cubic (Pm \bar 3 m) phase has been revealed near 753 K. In the non-centrosymmetric P4mm symmetry group, the difference in relative displacement between Pb and O along the c-axis is much larger than that between Ti and O. The Pb and Ti cations contribute sufficiently to polarization being shifted in the opposite direction compared with the shift of O atoms. Deviation from the linear changes in Debye-Waller factors and bonding distances in the tetragonal phases can be interpreted as a precursor phenomenon before the phase transition. Disturbance of the temperature factor Ueq for O is observed in the vicinity of the transition point, while Ueq values for Pb and Ti are continuously changing with increasing temperature. The O site includes the clear configurational disorder in the cubic phase. The polar local positional distortions remain in the cubic phase and are regarded as the cause of the paraelectricity. Estimated values of the Debye temperature ΘD for Pb and Ti are 154 and 467 K in the tetragonal phase and decrease 22% in the high-temperature phase. Effective potentials for Pb and Ti change significantly and become soft after the phase transition.
More Related Videos
Related Concept Videos
Crystal Field Theory - Tetrahedral and Square Planar Complexes
Crystal field theory (CFT) is applicable to molecules in geometries other than octahedral. In octahedral complexes, the lobes of the dx2−y2 and dz2 orbitals point directly at the ligands. For tetrahedral complexes, the d orbitals remain in place, but with only four ligands located between the axes. None of the orbitals points directly at the tetrahedral ligands. However, the dx2−y2 and dz2 orbitals (along the Cartesian axes) overlap with the ligands less than the dxy,...
Determination of Crystal Structures
Crystallographic Point Groups

