Implementation Considerations, Not Topological Differences, Are the Main Determinants of Noise Suppression Properties

Gentian Buzi1, Mustafa Khammash1

  • 1Control Theory and Systems Biology, Department of Biosystems Science and Engineering, ETH Zurich, Zurich, Switzerland.

Related Concept Videos

Effects of feedback01:24

Effects of feedback

Feedback in control systems plays a critical role in shaping various operational parameters, extending beyond simple error reduction to influence stability, bandwidth, gain, impedance, and sensitivity. Understanding these effects requires examining a basic feedback system characterized by defined input, output, error, and feedback signals.
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...
1.1K
Feedback control systems01:26

Feedback control systems

Feedback control systems are categorized in various ways based on their design, analysis, and signal types.
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
783
Second-order Op Amp Circuits01:19

Second-order Op Amp Circuits

Implementing second-order low-pass filters in audio systems is crucial in refining audio signals by eliminating undesirable high-frequency noise. These filters typically involve second-order op-amp circuits configured as voltage followers, encompassing two nodes with distinct storage elements.
The analysis of such circuits follows a systematic approach, similar to the second-order RLC circuits. In practical scenarios, bulky inductors are rarely employed due to their size and weight. This means...
690
Inverting and Non-inverting OpAmps01:20

Inverting and Non-inverting OpAmps

In an inverting amplifier, the input voltage is connected through a resistor to the inverting terminal. Meanwhile, the non-inverting terminal is grounded and a feedback resistor is established between the inverting and output terminal, as depicted in Figure 1.
2.0K
Positive and Negative Feedback Loops01:18

Positive and Negative Feedback Loops

Animal organs and organ systems constantly adjust to internal and external changes through a process called homeostasis ("steady state"). Examples of these changes include regulation of the level of glucose or calcium in the blood or internal responses to external temperatures. Homeostasis requires  maintaining an internal dynamic equilibrium:
26.0K
Negative and Positive Feedback01:18

Negative and Positive Feedback

36.6K