Related Experiment Video
Updated: Mar 20, 2026

Ohmic Contact Fabrication Using a Focused-ion Beam Technique and Electrical Characterization for Layer Semiconductor Nanostructures
Published on: December 5, 2015
Anti-Ambipolar Field-Effect Transistors Based On Few-Layer 2D Transition Metal Dichalcogenides
Yongtao Li1, Yan Wang1, Le Huang1
1State Key Laboratory of Superlattices and Microstructures, Institute of Semiconductors, Chinese Academy of Sciences , Beijing 100083, P. R. China.
Abstract:
Two-dimensional (2D) materials and their related van der Waals heterostructures have attracted considerable interest for their fascinating new properties. There are still many challenges in realizing the potential of 2D semiconductors in practical (opto)electronics such as signal transmission and logic circuit, etc. Herein, we report the gate-tunable anti-ambipolar devices on the basis of few-layer transition metal dichalcogenides (TMDs) heterostructures to gain higher information storage density. Our study shows that carrier concentration regulated by the gate voltage plays a major role in the "anti-ambipolar" behavior, where the drain-source current can only pass through in specific range of gate voltage (Vg) and it will be restrained if the Vg goes beyond the range. Several improved strategies were theoretically discussed and experimentally adopted to obtain higher current on/off ratio for the anti-ambipolar devices, such as choosing suitable p-/n-pair, increasing carrier concentration by using thicker-layer TMDs, and so on. The modified SnS2/WSe2 device with the current on/off ratio exceeding 200 and on-state Vg ranging from -20 to 0 V was successfully achieved. On the basis of the anti-ambipolar field-effect transistors (FETs), we also reveal the potential of three-channel device unit for signal processing and information storage. With the equal quantity N of device units, 3(N) digital signals can be obtained from such three-channel devices, which are much larger than 2(N) ones obtained from traditional two-channel complementary metal oxide semiconductors (CMOS).
Related Concept Videos
Field Effect Transistor
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Schottky Barrier Diode
MOSFET
In an n-MOSFET, the structure includes n-type source and drain...
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The...
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...

