Evaluation of water, sanitation and hygiene program outcomes shows knowledge-behavior gaps in Coast Province, Kenya

Michael Paul Schlegelmilch1, Amyn Lakhani2, Leslie Duncan Saunders1

  • 1School of Public Health, University of Alberta, Edmonton, Alberta, Canada.

Abstract

Related Concept Videos

Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
640
Handwashing III: During the Procedure and Post-Procedure Steps01:15

Handwashing III: During the Procedure and Post-Procedure Steps

To wash hands properly, follow these steps:
3.2K
Handwashing II: Pre-procedure and Initial Procedure Steps01:19

Handwashing II: Pre-procedure and Initial Procedure Steps

The pre-procedure steps of handwashing include removing jewelry and rolling up sleeves. However, many organizations allow staff to wear wedding rings.
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury.  The nails must be short and clean, without nail...
1.6K
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
441
Handwashing I: Introduction and Types of Equipment01:18

Handwashing I: Introduction and Types of Equipment

Handwashing is hand hygiene with plain or antimicrobial soap and water to physically remove dirt, organic material, and microorganisms. However, it may not kill all microorganisms. The handwashing procedure requires a hand wash basin, liquid soap, paper towels, a domestic waste bin, and disposable nail cleaner as optional equipment.
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
5.2K