Related Experiment Video

Updated: Mar 19, 2026

Construction of a Low-cost Mobile Incubator for Field and Laboratory Use
07:50

Construction of a Low-cost Mobile Incubator for Field and Laboratory Use

Published on: March 19, 2019

14.8K

Early warning of changing drinking water quality by trend analysis

Jani Tomperi1, Esko Juuso1, Kauko Leiviskä1

  • 1Control Engineering, Faculty of Technology, University of Oulu, PO Box 4300, FIN-90014 University of Oulu, Oulu, Finland

Journal of Water and Health
|June 10, 2016
PubMed

More Related Videos

Continuous Hydrologic and Water Quality Monitoring of Vernal Ponds06:37

Continuous Hydrologic and Water Quality Monitoring of Vernal Ponds

Published on: November 13, 2017

9.7K
Watershed Planning within a Quantitative Scenario Analysis Framework12:44

Watershed Planning within a Quantitative Scenario Analysis Framework

Published on: July 24, 2016

8.7K

Related Concept Videos

Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
640
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
441
Precipitation Titration: Endpoint Detection Methods01:19

Precipitation Titration: Endpoint Detection Methods

In argentometric precipitation titrations, endpoints can be detected visually by the Mohr, Volhard, and Fajans methods. In the Mohr method, adding a soluble chromate indicator gives an initial yellow color to the analyte solution. As the titrant is added, the first excess of silver ions forms a red silver chromate precipitate, marking the endpoint. The solution pH should be maintained at about 8 by adding solid CaCO3.
In the Volhard method, a standard excess of AgNO3 is first added to the...
6.3K
Precipitation Titration Curve: Analysis01:21

Precipitation Titration Curve: Analysis

The precipitation titration curve demonstrates the change in concentration of one reactant with the volume of titrant added. During the titration of chloride ions with silver nitrate, the precipitation titration curve is divided into three regions: before, at, and after the equivalence point. Before the equivalence point, low redissolution of the sparingly soluble silver chloride precipitate gives a low silver ion concentration. However, in the second region, representing the equivalence point,...
2.0K
Derivatives: Problem Solving01:26

Derivatives: Problem Solving

Temperature-Dependent Growth of Brook TroutThe growth of brook trout is closely influenced by water temperature. Experimental data demonstrate how trout weight changes over a 24-day period in response to varying water temperatures. At lower temperatures, such as 15.5 degrees Celsius, brook trout show significant weight gain. However, as the temperature increases, the amount of weight gained steadily decreases. At the highest temperature measured, 24.4 degrees Celsius, trout experience a net...
140
Precipitation and Co-precipitation01:17

Precipitation and Co-precipitation

Precipitation and coprecipitation methods can be used to separate a mixture of ions in a solution. In qualitative inorganic analysis, ions that form sparingly soluble precipitates with the same reagent are separated based on the differences in solubility products. For example, consider the separation of Cu(II) and Fe(II) ions by precipitation as insoluble sulfides. First, copper(II) sulfide is precipitated by the addition of acidic H2S, where the dissociation of H2S is suppressed. Adding H2S...
5.5K