Related Experiment Video
Updated: Mar 19, 2026
A Reproducible Cartilage Impact Model to Generate Post-Traumatic Osteoarthritis in the Rabbit
Published on: November 21, 2023
Does the relative density of periarticular bone influence the failure pattern of intra-articular fractures?
K D Tetsworth1, A Y Borshch1, C E Dlaska2
1Department of Orthopaedic Surgery, The Royal Brisbane and Women's Hospital, Brisbane, Australia; University of Queensland, School of Medicine, Brisbane, Australia.
Introduction:
The architecture of joints almost certainly influences the nature of intra-articular fractures, and the concavity is much more likely to fail than the associated convexity. However, local differences in periarticular bone density potentially also plays a critical role. The purpose of this study was to investigate if there was any difference in periarticular bone density in intra-articular fractures between the two opposing joint surfaces, comparing the convexity to the concavity.
Materials And Methods:
We retrospectively identified a series of 1003 intra-articular fractures of the hip, knee, and ankle; 129 of these patients had previously undergone CT scanning during their routine clinical assessment. Periarticular bone density was assessed using Hounsfield Units (HU) as a measure of the composite density of the adjacent bone. Bone density was compared between the opposite sides of each joint, to determine if a relationship exists between local bone density and the risk of articular surface fracture.
Results:
There was a statistically significant difference in density between the two opposing surfaces, with the convexity 19% more dense than the concavity (p=0.0001). The knee exhibited the largest difference (55%), followed by the hip (18%); in the ankle, an inverse relationship was observed, and the concave surface was paradoxically denser (5%). There was no significant difference between those cases where the concavity failed in isolation compared to those where the convexity also failed (p=0.28).
Conclusion:
When the results were pooled for all three joints, there was a statistically significant higher local bone density demonstrated on the convex side of an intra-articular fracture. However, while this relationship was clearly exhibited in the knee, this was less evident in the other two joints; in the ankle the reverse was true, and the local bone adjacent to the concavity was found to have greater density. This suggests local bone density plays only a minor role in determining the nature of intra-articular fractures.
Related Concept Videos
01:27Fractures: Bone Repair
Minor fractures with no bone displacement are treated by immobilizing the fractured bone using a cast or splint. However, in the case of fractures with displaced bones, the broken bones are repositioned before immobilization to ensure successful healing without deformation and loss of function. The realignment of fractured bone ends is performed through a process called reduction. If the...
01:09Spongy Bone
Spongy bone is more porous, and less dense compared to compact bone. It is composed of concentric lamellae that are arranged irregularly to form the trabecular network. In some bones, the spaces between trabeculae contain red marrow, where...
01:27Compact Bone
Compact bone, also called cortical bone, is the denser, stronger of the two types of bone tissue. It is found under the periosteum and in the diaphyses of long bones, where it provides support and protection. The microscopic structural unit of compact bone is called an osteon, or haversian system. Each osteon is composed of concentric rings of calcified...
01:16Bones of the Lower Limb: Femur and Patella