Relative sensitivities of DCE-MRI pharmacokinetic parameters to arterial input function (AIF) scaling

Xin Li1, Yu Cai1, Brendan Moloney1

  • 1Advanced Imaging Research Center, Oregon Health & Science University, Portland, OR 97239, United States.

Related Concept Videos

Pharmacokinetic–Pharmacodynamic Relationship: Dose to Pharmacological Effect01:28

Pharmacokinetic–Pharmacodynamic Relationship: Dose to Pharmacological Effect

A drug’s dosage and pharmacokinetic properties determine how quickly it acts, how intense its effects are, and how long it lasts. Higher doses increase drug concentration at receptor sites, producing a hyperbolic curve when pharmacologic response is plotted against drug dose. Converting this scale to a log-linear format results in a sigmoidal curve, better representing dose–response relationships.For drugs following a one-compartment model, the pharmacologic response is directly...
89
Pharmacokinetic–Pharmacodynamic Relationship: Intensity of Dose-Effect Relationship01:23

Pharmacokinetic–Pharmacodynamic Relationship: Intensity of Dose-Effect Relationship

Pharmacodynamics explores the relationship between drug concentration and its effect. In a quantal response drug, the duration of action better correlates with drug concentration, while for graded effect drugs, the intensity of response is more relevant. This intensity depends on the dose, drug removal rate, and the region of the concentration–response curve.The concentration–response curve can be divided into three regions. Region 3 (80–100% maximum response) demonstrates...
104
Pharmacokinetic–Pharmacodynamic Relationship: Problems01:24

Pharmacokinetic–Pharmacodynamic Relationship: Problems

The empirical approach to drug therapy optimization relies on correlating pharmacological response with administered dosage. Such an approach can be costly, time-consuming, and often yields poor correlation due to variables like formulation factors and drug elimination characteristics. A more precise approach correlates response with plasma drug concentration or the amount of drug in the body, rather than dosage. This is achieved through pharmacokinetic-pharmacodynamic (PK/PD) modeling, which...
67
Pharmacokinetic–Pharmacodynamic Relationship: Model Components01:14

Pharmacokinetic–Pharmacodynamic Relationship: Model Components

Pharmacokinetic-pharmacodynamic (PK–PD) modeling is essential in drug development and clinical pharmacology. It provides a quantitative framework to predict drug behavior and response over time. This approach integrates pharmacokinetics (PK), which describes the drug's absorption, distribution, metabolism, and excretion, with pharmacodynamics (PD), which characterizes the drug’s biological effects and mechanisms of action.The disposition kinetics of a drug determine its plasma...
98
Pharmacodynamic Models: Additive and Proportional Drug Effect Model01:09

Pharmacodynamic Models: Additive and Proportional Drug Effect Model

Drug response models describe how pharmacological agents interact with biological systems to produce measurable effects. Baseline responses are inherent physiological activities without a drug significantly influencing the observed pharmacological outcomes. Depending on the drug response model employed, these baseline responses may combine with the drug's effect in either an additive or proportional manner.Additive Drug Response ModelIn the additive model, the drug effect is independent of the...
55
Pharmacodynamic Models: Linear Concentration–Effect Model01:15

Pharmacodynamic Models: Linear Concentration–Effect Model

The linear concentration–effect model, underpinned by the principle that pharmacological effect (E) is directly proportional to plasma drug concentration (C), emerges as a pivotal simplification of the Emax model for conditions where C is significantly less than EC50. This model portrays a linear trajectory of the concentration–effect relationship when drug levels are markedly below the EC50 threshold.Despite its inherent assumption of continuous effect augmentation with increasing...
53