Related Experiment Video
Updated: Mar 19, 2026

High-Resolution Neutron Spectroscopy to Study Picosecond-Nanosecond Dynamics of Proteins and Hydration Water
Published on: April 28, 2022
Probing the Distribution of Water in a Multi-Component System by Solid-State NMR Spectroscopy
Pinal Mistry1, Paroma Chakravarty2, Joseph W Lubach3
1Department of Pharmaceutics, University of Minnesota, Minneapolis, Minnesota, 55414, USA.
Purpose:
To characterize the distribution of water among various components in a powder blend using solid-state NMR spectroscopy.
Methods:
Water sorption behavior of theophylline anhydrate and excipients was determined by dynamic vapor sorption (DVS) and Karl Fischer Titration (KFT) after storing them in humidity chambers for 1 week at room temperature (RT) and calibration curves were generated for water content vs. (1)H T 1 relaxation times. Powder blends (either with microcrystalline cellulose or lactose as diluent) were stored at different relative humidity (RH) conditions and analyzed periodically using solid-state NMR, powder X-ray diffraction, and KFT.
Results:
Anhydrous theophylline converted to the hydrate at ≥ 84% RH. Based on the calibration curves of water content vs. relaxation times, the distribution of water in the powder blends was estimated. The total water content calculated using ssNMR was in good agreement with values measured using KFT. In blends stored at 90% RH, theophylline anhydrate-to-hydrate conversion did not occur in 1 week.
Conclusions:
The distribution of water in multi-component powder blends was successfully determined using correlation between (1)H T 1 relaxation times and total water content. Excipient water sorption inhibited hydrate formation in theophylline at 90% RH. Water distribution was affected by excipient type. The extent of water sorbed by excipients in blends was found to be different than their standalone equilibrium water content.
More Related Videos
11:47Concentration of Metabolites from Low-density Planktonic Communities for Environmental Metabolomics using Nuclear Magnetic Resonance Spectroscopy
Published on: April 7, 2012
09:32A New Straightforward Method for Lipophilicity logP Measurement using 19F NMR Spectroscopy
Published on: January 30, 2019
Related Concept Videos
¹H NMR: Interpreting Distorted and Overlapping Signals
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
Chemical Shift: Internal References and Solvent Effects
The internal reference compound generally used in NMR spectroscopy is tetramethylsilane (TMS). TMS is preferred because it is chemically inert, soluble in NMR solvents, and easily removable. Also, the highly shielded methyl protons in TMS yield an intense...
¹H NMR Signal Multiplicity: Splitting Patterns
¹H NMR: Complex Splitting
Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied...
¹H NMR of Labile Protons: Deuterium (²H) Substitution
2D NMR: Overview of Homonuclear Correlation Techniques
COSY90 is the standard two-dimensional (2D) COSY experiment that...