Difference magnitude is not measured by discrimination steps for order of point patterns

Journal of Vision
|July 6, 2016
PubMed

Related Concept Videos

Orders of Magnitude01:15

Orders of Magnitude

The order of magnitude of a number is the power of 10 that most closely approximates it. Thus, the order of magnitude estimates the scale (or size) of its value. To find the order of magnitude of a number, take the base-10 logarithm of the number and round it to the nearest integer. Then the order of magnitude of the number is simply the resulting power of 10.
The order of magnitude is simply a way of rounding numbers consistently to the nearest power of 10. This makes doing rough mental math...
27.9K
The Dot Product01:26

The Dot Product

Measuring how one directional quantity affects another along a specific path involves comparing their orientation and strength. When two such quantities are represented using direction and amount, a numerical result is computed to show how much one acts along the path of the other. This result comes from a rule combining both inputs' horizontal and vertical parts and adding the results.This calculation gives a single value that grows larger when both inputs point in similar directions and...
293
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.8K
Basic Discrete Time Signals01:16

Basic Discrete Time Signals

The unit step sequence is defined as 1 for zero and positive values of the integer n. This sequence can be graphically displayed using a set of eight sample points, showing a step function starting from n=0 and remaining constant thereafter.
The unit impulse or sample sequence is mathematically expressed as zero for all n values except at n=0, where it is one. The unit impulse sequence, denoted by δ(n), is the first difference of the unit step sequence, while the unit step sequence u(n) is the...
792
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
619
Differential Leveling01:12

Differential Leveling

Differential leveling is a precise method in surveying used to determine the elevation difference between two points. Its primary goal is to establish accurate vertical measurements to create level surfaces or grade lines critical for designing and constructing infrastructures such as roads, bridges, and buildings.The procedure for differential leveling begins with setting up and leveling the instrument at a point where the benchmark can be seen. The level rod is held on the benchmark (BM), and...
858