Related Experiment Video
Updated: Mar 17, 2026
A Finite Element Approach for Locating the Center of Resistance of Maxillary Teeth
Published on: April 8, 2020
Working Length Determination Using Cone-Beam Computed Tomography, Periapical Radiography and Electronic Apex Locator
André Luiz Gomide de Morais1, Ana Helena Gonçalves de Alencar2, Cyntia Rodrigues de Araújo Estrela3
1Dental School, Federal University of Goiás, Goiânia, GO, Brazil;
Introduction:
The purpose of this clinical study was to compare the accuracy of working length (WL) determination using cone-beam computed tomography (CBCT), conventional periapical radiographies and electronic apex locator.
Methods And Materials:
This study was conducted during root canal treatment of 19 patients with a total of 30 single-rooted teeth diagnosed with apical periodontitis. After taking the initial parallel periapical radiographies, the initial file was advanced into the canal until the WL was detected by the apex locator. Subsequently, the WL was measured and WL radiographies were taken with the file set in the canal. Afterwards, CBCT images were acquired. These three measurements were tabulated and compared and the data were analyzed using the Friedman test. The level of significance was set at 0.05.
Results:
The mean values for WL determination by electronic apex locator, periapical radiograph and CBCT images were 22.25, 22.43 and 22.65, respectively which was not statistically significant (P>0.05).
Conclusion:
Working length determination using CBCT images was precise when compared to radiographic method and electronic apex locator.
