A methodology to determine the maximum value of weighted Gini-Simpson index

José Pinto Casquilho1

  • 1Universidade Nacional Timor Lorosa'e, Rua Formosa, Díli, Timor-Leste ; Centro de Ecologia Aplicada ''Prof Baeta Neves'', InBio, Instituto Superior de Agronomia, Universidade de Lisboa, Tapada da Ajuda, 1349-017 Lisbon, Portugal.

Springerplus
|August 10, 2016
PubMed

Related Concept Videos

Weighted Mean00:57

Weighted Mean

While taking the arithmetic, geometric, or harmonic mean of a sample data set, equal importance is assigned to all the data points. However, all the values may not always be equally important in some data sets. An intrinsic bias might make it more important to give more weightage to specific values over others.
For example, consider the number of goals scored in the matches of a tournament. While computing the average number of goals scored in the tournament, it may be more important to...
7.3K
Quantifying and Rejecting Outliers: The Grubbs Test01:02

Quantifying and Rejecting Outliers: The Grubbs Test

Sometimes, a data set can have a recorded numerical observation that greatly  deviates from the rest of the data. Assuming that the data is normally distributed, a statistical method called the Grubbs test can be used to determine whether the observation is truly an outlier.  To perform a two-tailed Grubbs test, first, calculate the absolute difference between the outlier and the mean. Then, calculate the ratio between this difference and the standard deviation of the sample. This...
4.4K
Simpson's Rule II01:28

Simpson's Rule II

In warehouse roofing applications, corrugated or curved metal sheets are commonly used to improve structural strength, water drainage, and ventilation efficiency. To accurately estimate material requirements and optimize design parameters, engineers must determine the curved surface area of these sheets. Because the sheet profiles often repeat smoothly along their length, they can be effectively approximated by parabolic curves, enabling the use of numerical integration techniques for area...
132
Test for Homogeneity01:23

Test for Homogeneity

The goodness–of–fit test can be used to decide whether a population fits a given distribution, but it will not suffice to decide whether two populations follow the same unknown distribution. A different test, called the test for homogeneity, can be used to conclude whether two populations have the same distribution. To calculate the test statistic for a test for homogeneity, follow the same procedure as with the test of independence. The hypotheses for the test for homogeneity can...
2.5K
Wilcoxon Signed-Ranks Test for Median of Single Population01:14

Wilcoxon Signed-Ranks Test for Median of Single Population

The Wilcoxon signed-rank test for the median of a single population is a nonparametric test used to evaluate whether the median of a population differs from a specified value. Unlike parametric tests, it does not require data to follow a normal distribution, making it suitable for non-normal or small samples. The test begins by calculating the difference (d) between each observation and the hypothesized median. The absolute values of these differences are ranked in ascending order, with ties...
496
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
613