THE TIBIAL APERTURE SURFACE ANALYSIS IN ANTERIOR CRUCIATE LIGAMENT RECONSTRUCTION PROCESS
Introduction:
The tibial tunnel aperture in the anterior cruciate ligament reconstruction is usually analyzed as an ellipse, generated as an intersection between a tibial plateau and a tibial bone tunnel. The aim of this study is to show that the tibial tunnel aperture, which utilizes 3D tibial surface bone model, differs significantly from common computations which present the tibial tunnel anterior cruciate ligament aperture surface as an ellipse.
Material And Methods:
An interactive program system was developed for the tibial tunnel aperture analysis which included the real tibia 3D surface bone model generated from a series of computed tomography images of ten male patients, their mean age being 25 years. In aperture calculation, the transverse drill angle of 10 degrees was used, whereas sagittal drill angles of 40 degrees, 50 degrees and 60 degrees were used with the drill-bit diameter set to 10 mm. The real 3D and 2D tibial tunnel aperture surface projection was calculated and compared with an ellipse.
Results:
According to the calculations, generated 3D aperture surfaces were different for every patient even though the same drill parameters were used. For the sagittal drill angles of 40 degrees, 50 degrees and 60 degrees, the mean difference between the projected 3D and 2D area on the tibial plateau was 19.6 +/- 5.4%, 21.1 +/- 8.0% and 21.3 +/- 9.6%, respectively. The difference between the projected 3D area on the tibial plateau and ellipse surface was 54.8 +/- 16.3%, 39.6 +/- 10.4% and 25.0 +/- 8.0% for sagittal drill angles of 40 degrees, 50 degrees and 60 degrees, respectively.
Conclusion:
The tibial tunnel aperture surface area differs significantly from the ellipse surface area, which is commonly used in the anterior cruciate ligament reconstruction analysis. Inclusion of the 3D shape of the tibial attachment site in the preoperative anterior cruciate ligament reconstruction planning process can lead to a more precise individual anatomic anterior cruciate ligament reconstruction on the tibial bone. Both tibial aperture area generated in 3D and its projection on a tibial plateau are larger than the ellipse surface; therefore, individual characteristics of each patient have to be taken into consideration.
