Isotopic determination of selenium in biological materials with inductively coupled plasma mass spectrometry

A method for the isotopic determination of selenium in biological matrices is described. The method is based on hydride generation inductively coupled plasma mass spectrometry (ICP-MS). The development is specifically related to the requirements of stable isotope tracer studies in human subjects. The method is based on isotope dilution using 82Se as the in vitro spike and can quantify the 74Se and 77Se contents of samples. It involves wet oxidation (HNO3 - H2O2 or HNO3 - HClO4) of the 82Se-spiked matrix, reduction to selenite by boiling with HCl followed by measurement of the isotope ratios (82Se/77Se and 74Se/77Se) in the gas stream (H2Se) generated from on-line reduction of the sample selenite with NaBH4. Compared with the isotopic signal resulting from a selenite solution containing 5 ng ml-1 of Se, the total sample blank contributions at m/z = 74, 77 and 82 were less than 5% of the respective isotope signal. Worst-case absolute detection limits were 0.2-0.9 ng of Se, depending on the isotope used. Ion beam intensity ratios were measured with an over-all precision [relative standard deviation (RSD)] of 1% for both isotope pairs. Measured ratios (MRa/b) were stable during a given day's operation within the expected precision of the measurements but varied for different days. The magnitude of MRa/b was generally independent of the nature of the matrix. Highly linear relationships were found between ion beam intensity ratios (MRa/b) and the corresponding true isotope ratios for calibration solutions whose isotope ratios had been altered by as much as one order of magnitude.(ABSTRACT TRUNCATED AT 250 WORDS)