Related Experiment Video
Updated: Mar 15, 2026
Fabricating Superhydrophobic Polymeric Materials for Biomedical Applications
Published on: August 28, 2015
In vitro assessment of an antibacterial quaternary ammonium-based polymer loaded with chlorhexidine for the coating
B Pérez-Köhler1,2, M Fernández-Gutiérrez3,4, G Pascual5,4
1Department of Surgery, Medical and Social Sciences, Faculty of Medicine and Health Sciences, University of Alcalá, Ctra. Madrid-Barcelona, Km 33,600, Alcalá de Henares, 28871, Madrid, Spain. barbara.perez@uah.es.
Purpose:
This study assesses the use of an absorbable polymer loaded with chlorhexidine (CHX) as an antibacterial coating for polypropylene (PP) meshes employed in hernia repair.
Methods:
The polymer N,N-dimethyl-N-benzyl-N-(2-methacryloyloxyethyl) ammonium bromide was loaded with CHX (1 % w/w). Fragments (1 cm2) of Optilene® Mesh Elastic were coated either with the unloaded (POL) or CHX-loaded polymer (POL-CHX). Uncoated fragments (PP) served as controls. The release kinetics of the POL-CHX coating was monitored by HPLC. Sterile fragments were placed on agar plates previously contaminated with 106 CFU of Staphylococcus aureus (Sa) ATCC25923, Staphylococcus epidermidis (Se) ATCC12228, or Escherichia coli (Ec) ATCC25922 and incubated at 37 °C for 1/2/7 days. At each time point, inhibition halos were measured and bacterial adhesion to the meshes quantified by sonication and scanning electron microscopy. Coating cytotoxic effects were examined on cultured fibroblasts.
Results:
The polymer coating gradually released CHX over 3 days. Inhibition halos were produced only around the POL-CHX-coated meshes and these were significantly smaller for Ec than Sa or Se (p < 0.01). While POL-CHX prevented bacterial adhesion to the mesh, the reduced bacterial yields over time were observed for the POL-coated versus control PP meshes (p < 0.001). By day 7, only Ec remained attached to the surface of control meshes. The POL coating was not cytotoxic, yet POL-CHX reduced the viability of cultured fibroblasts.
Conclusions:
When loaded with the antiseptic CHX, this quaternary ammonium-based polymer coating released its contents in a controlled manner indicating its potential prophylactic use to reduce the risk of infection following PP mesh implantation.
