Expeditious method to determine uranium in the process control samples of chemical plant separating (233)U from...

Analysis of U in the samples containing a significant proportion of (232)U and high concentration of Th is of great concern. Transmutation of Th in the nuclear power reactor produces a notable quantity of (232)U (half life 68.9 years) along with fissile isotope (233)U. The decay series of (232)U is initiated with (228)Th (half life 1.9 year) and it is followed by several short lived α emitting progenies, (224)Ra, (220)Rn, (216)Po, (212)Bi and (212)Po. Even at the smallest contamination of (228)Th in the sample, a very high pulse rate of α emission is obtained, which is to be counted for the radiometric determination of [U]. A commercially available anionic type of extractant Alamine®336 is used to obtain the selective extraction of U from other alpha active elements and fission products present in the sample. Experimental conditions of liquid-liquid extraction (LLE) are optimized for obtaining maximum decontamination and recovery of U in the organic phase. The effect of some interfering ionic impurities in the sample on the process of separation is investigated. Depending on the level of the concentration of U in the samples, spectrophotometry or radiometry methods are adopted for its determination after separation by LLE. Under optimized experimental conditions, i.e. 5.5M HCl in the aqueous phase and 0.27M Alamin®336 in the organic phase, the recovery of U is about 100%, the decontamination factor with respect to Th is >2000 and the extraction of fission products like (90)Sr, (144)Ce and (134,137)Cs is negligible. The detection limit for [U] using α radiometry is 10mg/L, even in presence of >100g/L of Th in the sample. Accuracy and precision for the determination of U is also assessed. Reproducibility of results is within 5%. This method shows very good agreement with the results obtained by mass spectrometry.