Related Experiment Video
Updated: Mar 15, 2026

Electrochemically and Bioelectrochemically Induced Ammonium Recovery
Published on: January 22, 2015
Electro-biocatalytic treatment of petroleum refinery wastewater using microbial fuel cell (MFC) in continuous mode
Sandipam Srikanth1, Manoj Kumar1, Dheer Singh1
1Industrial Biotechnology Department, Research and Development Center, Indian Oil Corporation Limited, Sector-13, Faridabad, Haryana 121007, India.
Abstract:
Refinery wastewater (RW) treatment in microbial fuel cell (MFC) was studied in batch mode operation followed by continuous mode operation with 8h and 16h hydraulic retention time (HRT). The MFC performance was evaluated in terms of power density, organics removal, specific contaminants (oil & grease, phenol and sulfide) removal and energy conversion efficiency with respect to operation mode. Higher power density of 225±1.4mW/m2 was observed during continuous mode operation with 16h HRT along with a substrate degradation of 84.4±0.8% including the 95±0.6 of oil content. The columbic efficiency during this operation was about 2±0.8% and the projected power yield was 340±20kWh/kg CODR/day. Batch mode operation also showed good substrate degradation (81±1.8%) but took longer HRT which resulted in significantly low substrate degradation rate (0.036±0.002kgCODR/m3-day) over continuous mode operation (1.05±0.01kgCODR/m3-day). Overall, current study depicted the possibility of utilizing RW as substrate in MFC for power generation along with its treatment.
Related Concept Videos
Environmental Applications of Microorganisms
Bioremediation
Lipid Catabolism
Batteries and Fuel Cells

