Accurate Exchange-Correlation Energies for the Warm Dense Electron Gas

Fionn D Malone1, N S Blunt2,3, Ethan W Brown4

  • 1Department of Physics, Imperial College London, Exhibition Road, London SW7 2AZ, United Kingdom.

Physical Review Letters
|September 24, 2016
PubMed

Related Concept Videos

Heat Capacities of an Ideal Gas III01:25

Heat Capacities of an Ideal Gas III

The number of independent ways a gas molecule can move along straight line, rotate, and vibrate is called its degrees of freedom. Supposing d represents the number of degrees of freedom of an ideal gas, the molar heat capacity at constant volume of an ideal gas in terms of d is
3.5K
Heat Capacities of an Ideal Gas II01:23

Heat Capacities of an Ideal Gas II

For a system that undergoes a thermodynamic process at a constant volume condition, the heat absorbed is used only to increase the system's internal energy and not for doing any kind of work. While for a system undergoing a thermodynamic process under a constant pressure condition, the amount of heat absorbed is used not only for increasing the internal energy (as a function of temperature) but also for doing some work. The molar heat capacity is the amount of heat required to increase the...
3.9K
Heat Capacities of an Ideal Gas I01:14

Heat Capacities of an Ideal Gas I

Heat capacity is the ratio of heat absorbed by the substance corresponding to its temperature change. It is also called thermal capacity and the SI unit of heat capacity is J/K. Whereas, specific heat capacity is defined as the amount of heat necessary to change the temperature of 1 kg of a substance by 1 K and is also called massic heat capacity. Its SI unit is J/kg⋅K.
Molar heat capacity quantifies the ratio of the amount of heat added (or removed) to increase (or decrease) the...
4.4K
Atomic Spectroscopy: Effects of Temperature01:27

Atomic Spectroscopy: Effects of Temperature

Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
1.0K
The Energies of Atomic Orbitals03:21

The Energies of Atomic Orbitals

In an atom, the negatively charged electrons are attracted to the positively charged nucleus. In a multielectron atom, electron-electron repulsions are also observed. The attractive and repulsive forces are dependent on the distance between the particles, as well as the sign and magnitude of the charges on the individual particles. When the charges on the particles are opposite, they attract each other. If both particles have the same charge, they repel each other.
30.8K
The Van der Waals Equation01:26

The Van der Waals Equation

The ideal gas law is based on two simplifying assumptions: first, that there are no intermolecular attractions between gas molecules, and second, that the volume occupied by the molecules themselves is negligible compared with the volume of the container. However, these assumptions don't hold up under all conditions - specifically, at high pressures and low temperatures, as gas tends to deviate from ideal gas behavior.The van der Waals equation is an enhanced version of the ideal gas law,...
91