On the characterization of claw-free graphs with given total restrained domination number

Xiaoming Pi1

  • 1Department of Mathematics, Harbin Normal University, Harbin, 150025 China.

Springerplus
|November 1, 2016
PubMed

Related Concept Videos

Graphical Representation of Inequalities01:28

Graphical Representation of Inequalities

The graph of the equation where y equals x squared forms a curve known as a parabola. This curve acts as a boundary in the coordinate plane, dividing it into distinct regions based on the relative position of points.When the equality sign in the equation is replaced with an inequality—such as greater than, less than, greater than or equal to, or less than or equal to—the graphical representation changes from a single curve into a broader shaded area that signifies the set of all...
336
Incomplete Dominance01:43

Incomplete Dominance

Gregor Mendel's work (1822 - 1884) was primarily focused on pea plants. Through his initial experiments, he determined that every gene in a diploid cell has two variants called alleles inherited from each parent. He suggested that amongst these two alleles, one allele is dominant in character and the other recessive. The combination of alleles determines the phenotype of a gene in an organism.
31.9K
Norton's Theorem01:14

Norton's Theorem

Norton's theorem is a fundamental principle stating that a linear two-terminal circuit can be substituted with an equivalent circuit, which comprises a current source (ⅠN) in parallel with a resistor (RN). Here, ⅠN represents the short-circuit current flowing through the terminals, and RN stands for the input or equivalent resistance at the terminals when all independent sources are deactivated. This implies that the circuit illustrated in Figure (a) can be exchanged with the one depicted...
1.7K
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...
1.0K
Routh-Hurwitz Criterion II01:19

Routh-Hurwitz Criterion II

In the application of the Routh-Hurwitz criterion, two specific scenarios can arise that complicate stability analysis.
The first scenario occurs when a singular zero appears in the first column of the Routh table. This situation creates a division by zero issues. To resolve this, a small positive or negative number, denoted as epsilon (∈), is substituted for the zero. The stability analysis proceeds by assuming a sign for ∈. If ∈ is positive, any sign change in the first...
1.2K
Graphs of Functions01:30

Graphs of Functions

Graphs of functions provide a visual representation of how output values change in response to varying inputs. Each point on the graph corresponds to an ordered pair, where the x-coordinate (independent variable) determines the horizontal position and the y-coordinate (dependent variable) determines the vertical position. Linear functions like y = x give a straight line, indicating a constant rate of change.Nonlinear functions display more complex behaviors. Even power functions generate...
446