Related Experiment Video

Updated: Mar 12, 2026

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
10:17

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier

Published on: July 12, 2017

12.1K

Influence of the third energy level on the gain dynamics of EDFAs: analytical model and experimental validation

Omar De Varona, Michael Steinke, Dietmar Kracht

    Optics Express
    |November 10, 2016
    PubMed

    More Related Videos

    Quasi-light Storage for Optical Data Packets07:45

    Quasi-light Storage for Optical Data Packets

    Published on: February 6, 2014

    11.4K
    Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements14:18

    Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements

    Published on: February 28, 2016

    12.0K

    Related Concept Videos

    Small-Signal Analysis of BJT Amplifiers01:21

    Small-Signal Analysis of BJT Amplifiers

    Small signal analysis is a fundamental approach used in electronics to understand how a Bipolar Junction Transistor (BJT) amplifier processes signals. In the active region, the BJT is designed for linear amplification. The transistor's behavior under these conditions is governed by its instantaneous base-emitter voltage VBE, a sum of the DC bias VBE, and a small AC signal VBE, resulting in the collector current iC. Here, the collector current has a DC component and an AC component.
    1.9K
    Small-Signal Analysis of MOSFET Amplifiers01:23

    Small-Signal Analysis of MOSFET Amplifiers

    In small-signal analysis, a MOSFET transistor amplifier acts as a linear amplifier when operating in its saturation region. The gate-to-source voltage (VGS) of the MOSFET is the sum of the DC biasing voltage and the small time-varying input signal. This combination sets up the operating point and modulates the drain current (ID) that flows from the drain to the source. When a small AC signal is superimposed on the DC bias voltage at the gate, the instantaneous drain current comprises three...
    1.2K
    Frequency Response of BJT01:24

    Frequency Response of BJT

    The frequency response of a Bipolar Junction Transistor (BJT) in a common-emitter configuration is critical to its functionality, especially in applications involving amplification of alternating current (AC) signals. This response can be analyzed through low-frequency and high-frequency equivalent circuits, considering various internal parameters and external conditions.
    Low-Frequency Response: At low frequencies, the behavior of the BJT is determined by its DC bias point, which is set by the...
    1.5K
    Pharmacodynamic Models: Emax Drug–Concentration Effect Model01:18

    Pharmacodynamic Models: Emax Drug–Concentration Effect Model

    The Emax drug-concentration effect model is central to pharmacodynamics in drug discovery and development. This model is predicated on the receptor occupancy theory, which posits that the effect of a drug is directly related to the number of receptors occupied by the drug and the resultant complex formation.The model describes the reversible interaction between a drug (C) and a receptor (R) to form a drug-receptor complex (RC). The kinetics of this interaction are quantified by an equation that...
    103
    Dynamic Modulus of Elasticity of Concrete01:16

    Dynamic Modulus of Elasticity of Concrete

    The dynamic modulus of elasticity assesses how a concrete structure deforms under impact or dynamic loads. It is typically higher than the static modulus of elasticity, measured under slow, steady loading conditions.
    The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
    1.1K