Related Experiment Video
Updated: Mar 12, 2026

Resolving Water, Proteins, and Lipids from In Vivo Confocal Raman Spectra of Stratum Corneum through a Chemometric Approach
Published on: September 26, 2019
Non-invasive Quantitative Analysis of Specific Fat Accumulation in Subcutaneous Adipose Tissues using Raman
Phiranuphon Meksiarun1, Bibin B Andriana1, Hiroko Matsuyoshi1
1Department of Biomedical Chemistry, School of Science and Technology, Kwansei Gakuin University 2-1, Gakuen, Sanda, Hyogo, 669-1337 Japan.
Abstract:
Subcutaneous adipose tissue (SAT), visceral adipose tissue (VAT), and fat beneath the dermis layer were investigated using a ball lens top hollow optical fiber Raman probe (BHRP). Hamsters were fed with trilinolein (TL) and tricaprin (TC) for six weeks and measurements were carried out every two weeks. The BHRP with an 800 μm diameter fused-silica ball lens was able to obtain information on the subcutaneous fat in a totally non-invasive manner. Changes in the concentration of TL and TC during the treatment were analyzed, and the relationship between fat accumulation and dietary fat was studied. It was found that SAT had, in general, a higher degree of unsaturation than VAT. The accumulation rate of TC found in SAT and VAT was 0.52 ± 0.38 and 0.58 ± 0.4%, respectively, while the TL accumulation rate was 4.45 ± 1.6 and 4.37 ± 2.4%, respectively. The results suggest different metabolic pathways for TC, a typical medium-chain fatty acid, and TL, a long-chain unsaturated fatty acid. Raman subsurface spectra were successfully obtained and used to analyze the subcutaneous fat layer. The accumulation rates of TL and TC found in skin fat were 5.01 ± 3.53% and 0.45 ± 0.36%, respectively. The results demonstrate the high feasibility of Raman spectroscopy for non-invasive analysis of adipose tissue.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

