Hydration affects the physical and mechanical properties of baleen tissue

Alexander J Werth1, Robert W Harriss1, Michael V Rosario2

  • 1Department of Biology, Hampden-Sydney College , Hampden-Sydney , VA 23943 , USA.

Royal Society Open Science
|November 18, 2016
PubMed

Related Concept Videos

Effect of Sea Water on Concrete01:22

Effect of Sea Water on Concrete

Concrete exposed to seawater can undergo degradation like the dissolution of ettringite and gypsum, increasing the material's porosity and decreasing its strength. In contrast, the crystallization of salts within the concrete's pores can cause expansion, particularly above the waterline where evaporation occurs. Nonetheless, this expansion only happens when seawater, enabled by the concrete's permeability, manages to infiltrate the structure.
Concrete in areas between tide marks,...
1.2K
Tonicity in Animals01:16

Tonicity in Animals

Tonicity describes the amount of solute in a solution. The measure of the tonicity of a solution, or the total amount of solutes dissolved in a specific amount of solution, is called its osmolarity. Three terms—hypotonic, isotonic, and hypertonic—are used to relate the osmolarity of a cell to the osmolarity of the extracellular fluid that contains the cells. In a hypotonic solution, such as tap water, the extracellular fluid has a lower concentration of solutes than the fluid inside...
8.6K
Tonicity in Animals00:59

Tonicity in Animals

The tonicity of a solution determines if a cell gains or loses water in that solution. The tonicity depends on the permeability of the cell membrane for different solutes and the concentration of nonpenetrating solutes in the solution within and outside of the cell. If a semipermeable membrane hinders the passage of some solutes but allows water to follow its concentration gradient, water moves from the side with low osmolarity (i.e., less solute) to the side with higher osmolarity (i.e.,...
127.9K
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
678