MTF Measurement of MR Blurring in Liver Dynamic MRI with Gd-EOB-DTPA

During the arterial phase acquisition of Gd-EOB-DTPA examinations, use of a small volume of the Gd-EOB-DTPA may make it difficult the encoding center of the k-space, and produce blurring. The previous studies revealed the encoding technique of the k-space was one of the most important reasons. However, there is no report to discuss the reasons with quantitative evaluations. The purpose of this study was to quantitatively evaluate the characteristics of the artifacts using different k-space encoding techniques (centric-view ordering (CVO) and sequential-view ordering (SVO)) for liver dynamic MRI in computer simulation study. This simulation study consists of the following steps. First of all, the creation of a time intensity curve, and original simulation images at certain points among the one phase dynamic scanning. Secondly, creation-simulated MR echo data from the created original images using FFT, and encoding simulated k-space using the simulated MR echo data. Finally, a reconstruction of simulated dynamic MR images from the simulated k-space, and to evaluate each simulated MR images, we measured modulation transfer functions (MTFs) from the bar patterns of the reconstructed images. The results of the CVO simulation indicated that the bar patterns were blurring compared to the images encoded by the SVO. The results of the SVO simulation indicated that the bar patterns were not enhanced at late scan timings. In addition, the results of MTFs indicated that there was no edge enhancement at all scan timings and both encoding techniques. In conclusion, it is possible to quantitatively evaluate the characteristics of artifacts using MTF, which was measured by the bar patterns, in liver dynamic MRI.