Related Experiment Video
Updated: Mar 11, 2026

Treatment of Facial Deformities using 3D Planning and Printing of Patient-Specific Implants
Published on: May 23, 2020
Facial deformations during nasal continuous positive airway pressure therapy
Andrew Sims1, Anne Simmons2, Mark Hoffman3
1Graduate School of Biomedical Engineering, The University of New South Wales, Australia; ResMed Ltd., Australia.
Abstract:
Obstructive Sleep Apnoea (OSA), characterised by repeated collapse of the pharyngeal airway during sleep, causes cessation of breathing followed by arousal, restoring normality. Continuous Positive Airway Pressure (CPAP) is a non-invasive, effective treatment for OSA where positive pressure is applied to the airway through a mask, maintaining patency. Nasal masks are commonly used, contacting the face across the upper lip, sides of the nose and the nasal bridge. Despite health benefits, therapy compliance is sub-optimal, often due to poor mask fit and discomfort. Masks have been designed to conform to the facial profile, but have not taken into account facial deformations. The nature of facial deformations while undergoing CPAP therapy is unknown. This study investigates the facial deformations experienced by a patient while undergoing nasal CPAP therapy. Magnetic Resonance Imaging (MRI) scans of the face were acquired of participants in the reference configuration and while undergoing CPAP therapy. The CPAP scan volume was registered onto the reference volume prior to surface generation for each state. Perpendicular deformation was measured from the reference facial profile to the deformed profile. Large facial deformations were measured at the sides of the nose (4.6±1.6mm) and the upper lip (4.9±1.8mm) with much smaller deformations at the nasal bridge (2.4±0.2mm). When normalised by applied load and tissue thickness, no difference was found. These findings and techniques can be used to consider facial deformation in the development of future nasal CPAP masks to improve comfort and compliance to therapy.
More Related Videos
Related Concept Videos
Mechanical Ventilation III: Noninvasive Ventilation
Noninvasive Positive-Pressure Ventilation...
Cardiopulmonary Resuscitation II: ACLS Airway Management
Administering Oxygen by Nasal Cannula
Nasal Cannulas
A nasal cannula is a lightweight tube split into two prongs placed in the nostrils,...
Oxygen Delivering System I: Nasal Cannula and Face Mask
Nasal Cannula
A nasal cannula is a lightweight tube split at one end into two prongs and placed in the nostrils. It is typically used to deliver low to medium levels of oxygen.
Suggested flow rate: The suggested flow rate for a nasal cannula typically ranges between 1 and 6 L/min.
Oxygen percentage setting:...
Suctioning the Nasopharyngeal Airway
Equipment Required
Assessment of Airway, Skin Color, and Use of Accessory Muscles
Introduction
The initial evaluation of a patient's respiratory system...

