Related Experiment Video
Updated: Mar 11, 2026

A Two-interval Forced-choice Task for Multisensory Comparisons
Published on: November 9, 2018
Age effects in discrimination of intervals within accented tone sequences differing in accent type and sequence
Peter J Fitzgibbons1, Sandra Gordon-Salant1
1Department of Hearing and Speech Sciences, University of Maryland, College Park, Maryland 20742, USA.
Abstract:
The study measured listener sensitivity to increments in the duration of one or two target silent intervals embedded within unaccented tone sequences and sequences that featured a single accented component. The baseline unaccented sequences consisted of six 1000-Hz 40-ms tone bursts that were separated equally by silent intervals to establish a slower tone sequence rate, with tonal inter-onset intervals (IOIs) set to 200 ms, or a faster rate with tonal IOIs set to 100 ms. Stimulus accent was created by doubling the baseline duration of a single sequence component, either the second tone burst (tonal accent), or the second tonal IOI (interval accent). Duration difference limens for increments of the target interval(s) were measured adaptively by varying a single inter-tone silent interval or co-varying two successive inter-tone silent intervals; target intervals occurred at the third, or third and fourth, sequence locations. Listeners included younger normal-hearing adults and groups of older listeners with and without hearing loss. Discrimination for the two older groups was equivalent and poorer than that of the younger listeners, especially for the faster accented sequences. Discrimination was best for stimuli with two successive target intervals, indicating that target repetition within accented sequences acts to improve listener temporal sensitivity.
More Related Videos
09:09Foreign Accent and Forensic Speaker Identification in Voice Lineups: The Influence of Acoustic Features Based on Prosody
Published on: September 27, 2024
09:04Uncovering Beat Deafness: Detecting Rhythm Disorders with Synchronized Finger Tapping and Perceptual Timing Tasks
Published on: March 16, 2015
Related Concept Videos
Interval Level of Measurement
Data measured using the interval scale are similar to ordinal level data because they have a definite arrangement. However, in the interval level of measurement, the differences between data values are meaningful even though the data does not have a starting point.
Temperature is measured using the interval scale. It is measurable data, and the difference between...
Double Resonance Techniques: Overview
Spin decoupling is usually achieved by...
Perception of Sound Waves
The pitch of a sound depends on the frequency and the pressure amplitude of the source. Two sounds of the same...
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Doppler Effect - II
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original...