Aging Wiener-Khinchin theorem and critical exponents of 1/f^{β} noise

N Leibovich1, A Dechant1,2, E Lutz2

  • 1Department of Physics, Institute of Nanotechnology and Advanced Materials, Bar Ilan University, Ramat-Gan 52900, Israel.

Physical Review. E
|December 15, 2016
PubMed

Related Concept Videos

Finding Critical Values for Chi-Square01:18

Finding Critical Values for Chi-Square

Consider a curve representing sample data drawn randomly from a normally distributed population. One must construct confidence intervals to estimate or to test a claim regarding the population standard deviation. For example, a 95% confidence interval covers 95% of the area under the curve, and the remaining 5% is equally distributed on either side of the curve. To achieve such confidence intervals, one must determine the critical values. The critical values are simply the values separating the...
4.6K
F Distribution01:19

F Distribution

The F distribution was named after Sir Ronald Fisher, an English statistician. The F statistic is a ratio (a fraction) with two sets of degrees of freedom; one for the numerator and one for the denominator. The F distribution is derived from the Student's t distribution. The values of the F distribution are squares of the corresponding values of the t distribution. One-Way ANOVA expands the t test for comparing more than two groups. The scope of that derivation is beyond the level of this...
10.8K
Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
606
Improper Integrals: Infinite Intervals01:29

Improper Integrals: Infinite Intervals

An integral is classified as improper due to an infinite interval when at least one of its limits of integration extends to positive or negative infinity. In such cases, the region under the curve is unbounded, and standard techniques for evaluating definite integrals are not directly applicable. Instead, the improper integral is defined through a limiting process that allows one to determine whether the accumulated area remains finite despite the infinite domain.Application to Exponential...
173
Parametric Survival Analysis: Weibull and Exponential Methods01:14

Parametric Survival Analysis: Weibull and Exponential Methods

Parametric survival analysis models survival data by assuming a specific probability distribution for the time until an event occurs. The Weibull and exponential distributions are two of the most commonly used methods in this context, due to their versatility and relatively straightforward application.
Weibull Distribution
The Weibull distribution is a flexible model used in parametric survival analysis. It can handle both increasing and decreasing hazard rates, depending on its shape parameter...
1.2K
Limits with Oscillating Discontinuities01:19

Limits with Oscillating Discontinuities

An oscillating discontinuity is a type of discontinuity in which a function’s values fluctuate infinitely often as the input approaches a particular point. Unlike jump discontinuities, where the function suddenly shifts between two values, or infinite discontinuities, where the function diverges without bound, an oscillating discontinuity arises from rapid back-and-forth variation. Because the function never stabilizes toward a single value, no finite limit exists at that point.One of the...
565