Related Experiment Video
Updated: Mar 8, 2026

In situ Compressive Loading and Correlative Noninvasive Imaging of the Bone-periodontal Ligament-tooth Fibrous Joint
Published on: March 7, 2014
Experimental comparison between tractional and compressive stress on temporomandibular joint
S Nogami1, K Yamauchi1, Y Shimizu2
1Division of Oral and Maxillofacial Surgery, Department of Oral Medicine and Surgery, Tohoku University Graduate School of Dentistry, Sendai, Miyagi, Japan.
Objective:
We experimentally compared the effects of compressive and tractional mechanical stress on the temporomandibular joint (TMJ) of rabbits to assess the etiology of progressive condylar resorption.
Materials And Methods:
We performed a cortical osteotomy using custom-made devices that were lengthened by 0.25 mm every 12 h for 1 week after surgery. During this time, the rabbit TMJ was under compressive or tractional mechanical stress. The samples in each group were examined using micro-computed tomography and histological staining.
Results:
Scores for the area of bone resorption were higher in the compressive group than in the tractional group. Moreover, scores for the depth of bone resorption were higher in the compressive group than those in the tractional group. We observed a significantly higher prevalence of resorption in the subcondylar bone in the compressive group than in the tractional group. There were substantially more cells that were positive for tartrate-resistant acid phosphatase in the compressive group than in the control and tractional groups.
Conclusions:
The outcomes here suggest that excessive mechanical stress, particularly compressive mechanical stress, may significantly affect morphological bone change findings in the TMJ.
Related Concept Videos
True Stress and True Strain
In contrast, true stress offers a more precise portrayal. It is computed by dividing the...
Relation Between Tensile Strength and Compressive Strength of Concrete
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Bearing Stress
Due to the intricacy of these microforces, an average value, known as bearing stress, is often used by...
Stress-Strain Diagram
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes....

