Related Experiment Video

Updated: Aug 12, 2026

Design and Use of a Full Flow Sampling System (FFS) for the Quantification of Methane Emissions
08:18

Design and Use of a Full Flow Sampling System (FFS) for the Quantification of Methane Emissions

Published on: June 12, 2016

Freon: an unsuspected problem

V M Voge1

  • 1Aviation Medicine Department, Naval Hospital, Corpus Christi, TX.

Aviation, Space, and Environmental Medicine
|October 1, 1989
PubMed

More Related Videos

Measurement of Outgassing Rates of Steels08:32

Measurement of Outgassing Rates of Steels

Published on: December 13, 2016

Experimental System of Solar Adsorption Refrigeration with Concentrated Collector07:18

Experimental System of Solar Adsorption Refrigeration with Concentrated Collector

Published on: October 18, 2017

Related Concept Videos

Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
Refrigerators and Heat Pumps01:07

Refrigerators and Heat Pumps

Refrigerators or heat pumps are heat engines operating in a reverse direction. For a refrigerator, the focus is on removing heat from a specific area, whereas, for a heat pump, the focus is on dumping heat into one particular area. A refrigerator (or heat pump) absorbs heat Qc from the cold reservoir at Kelvin temperature Tc and discards heat Qh to the hot reservoir at Kelvin temperature Th, while work W is done on the engine’s working substance.
A household refrigerator removes heat from the...
Acute Respiratory Failure-I01:21

Acute Respiratory Failure-I

Acute respiratory failure is a condition characterized by the inability of the lungs to perform their primary function: gas exchange. This failure leads to insufficient oxygen levels (hypoxemia) in the blood, elevated carbon dioxide levels (hypercapnia), or both, causing critical impairment in organ function.
Definition: It is defined by specific criteria based on blood gas measurements. Hypoxemia happens when the partial pressure of oxygen (PaO2) falls below 60 mmHg. At the same time,...
Acute Respiratory Failure-II01:21

Acute Respiratory Failure-II

Type I Respiratory Failure, or hypoxemic respiratory failure, occurs when the partial pressure of oxygen (PaO2) in arterial blood falls below 60 mmHg while breathing room air without a corresponding increase in arterial carbon dioxide levels (PaCO2). This condition highlights a significant impairment in the lungs' capacity to oxygenate the blood.
The underlying physiological abnormalities that contribute to hypoxemic respiratory failure include:
Acute Respiratory Failure-III01:30

Acute Respiratory Failure-III

Hypercapnic respiratory failure, also known as Type 2 or ventilatory respiratory failure, is a severe condition characterized by the body's inability to effectively remove carbon dioxide (CO2) from the bloodstream. It leads to an arterial CO2 pressure (PaCO2) exceeding 45 mmHg and a blood pH above 7.35. This situation indicates that the body's ventilatory demand, or the ventilation needed to maintain normal PaCO2 levels, surpasses its supply or the maximum gas flow achievable without causing...
Acute Respiratory Failure-IV01:23

Acute Respiratory Failure-IV

Respiratory failure can manifest suddenly or gradually, characterized by a rapid decline in PaO2 and a rapid rise in PaCO2. This situation indicates a severe respiratory problem that may quickly become a life-threatening emergency. One of the early signs of hypoxemic Acute Respiratory Failure (ARF) is a change in mental status due to the brain's sensitivity to oxygen levels and changes in acid-base balance. Symptoms such as restlessness, confusion, and agitation suggest inadequate oxygen...