Related Experiment Video
Updated: Mar 7, 2026

Systematic Assessment of Mammalian Skull Specimens for Dental and Temporomandibular Joint Pathology
Published on: August 22, 2022
Bolton tooth size ratio among qatari population sample: An odontometric study
Hayder A Hashim1, Najah Al-Sayed1, Hashim Al-Hussain1
1Hamad Medical Corporation, Rumaila Hospital, Dental Centre, Orthodontic Division, Doha, Qatar.
Objectives:
To establish the overall and anterior Bolton ratio among a sample of Qatari population and to investigate whether there is a difference between males and females, as well as to compare the result obtained by Bolton.
Materials And Methods:
The current study consisted of 100 orthodontic study participants (50 males and 50 females) with different malocclusions and age ranging between 15 and 20 years. An electronic digital caliper was used to measure the mesiodistal tooth width of all maxillary and mandibular permanent teeth except second and third molars. The Student's t-test was used to compare tooth-size ratios between males and females and between the results of the present study and Bolton's result.
Results:
The anterior and overall ratio in Qatari individuals were 78.6 ± 3.4 and 91.8 ± 3.1, respectively. The tooth size ratios were slightly greater in males than that in females, however, the differences were not statistically significant (P > 0.05). There were no significant differences in the overall ratio between Qatari individuals and Bolton's results (P > 0.05), whereas statistical significant differences were observed in anterior ratio (P = 0.007).
Conclusions:
Within the limitation of the limitations of the present study, definite conclusion was difficult to establish. Thus, a further study with a large sample in each malocclusion group is required.
Related Concept Videos
Teeth
In the bud stage, the tooth germ (an aggregation of cells) starts to form in the developing jawbone. During the cap stage, the tooth germ differentiates into enamel organ, dental papilla, and dental sac, which will later develop into the tooth's enamel, dentin...
Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
Assessment of the Mouth
Mouth Inspection
The inspection begins with visually examining the mouth for symmetry, color, and size.
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Sample Proportion and Population Proportion
Detection of Gross Error: The Q Test

