Related Experiment Video
Updated: Mar 6, 2026

Intravitreous Injection for Establishing Ocular Diseases Model
Published on: October 1, 2007
Intravitreally Injected Fluid Dispersion: Importance of Injection Technique
Koen Willekens1, Geert Reyns2, Marjan Diricx2
1Department of Ophthalmology, University Hospitals Leuven, Leuven, Belgium.
Purpose:
The purpose of this study was to evaluate the dispersion of intravitreally injected solutions and investigate the influence of varying injection techniques.
Methods:
This was a prospective study using enucleated porcine eyes and ultra-high-resolution computed tomography (UHRCT) scanning to visualize iomeprol intravitreal dispersion. Sixty eyes were divided over 12 different groups according to the injection procedure: fast (2 seconds) or slow (10 seconds) injection speed and needle tip location (6- and 12-mm needle shaft insertion or premacular tip placement verified by indirect ophthalmoscopy). For each of these combinations, eyes were either injected with the combination of V20I (which is an analogue of ocriplasmin) and iomeprol or iomeprol alone. Distance to the macula and volume measurements were performed at 1, 2, 3, and 5 hours after injection.
Results:
The measured contrast bolus volume increases slowly over time to an average of 0.70 (P = 0.03), 1.04 (P = 0.006), and 0.79 (P = 0.0001) cm3 5 hours after the injection for the 6-mm needle shaft insertion, 12-mm needle shaft insertion, and premacular needle tip placement, respectively. The distance to the macular marker was significantly lower for premacular needle tip placement injections compared with 6- and 12-mm needle shaft insertion depths.
Conclusions:
Ultra-high-resolution computed tomography with three-dimensional reconstruction offers the possibility to study the dispersion of intravitreally injected solutions in a noninvasive manner. Intravitreal premacular solution delivery is possible with an indirect ophthalmoscope-guided injection technique and significantly reduces the time to reach the posterior pole in respect to 6- and 12-mm needle insertion depths. The speed of injection does not influence dispersion significantly.
Related Concept Videos
Parenteral Drug Delivery Systems: Injectables, Implants, and Infusion Devices
Routes of Drug Administration: Parenteral
The intravenous route (IV) of drug administration can be further categorized into two types. The bolus injection administers the entire dose rapidly, while an intravenous infusion slowly delivers smaller doses steadily.
The IV route is often...
Drug Delivery: Parenteral Route
There are three primary parenteral routes: intravenous (IV), intramuscular (IM), and subcutaneous (SC). The IV route introduces the drug directly into the bloodstream, ensuring immediate action. The IM route...
Drug Accumulation During Multiple Dosing: Repetitive IV Injections
Drug Accumulation During Multiple Dosing: Intermittent IV Infusions

