Hip joint geometry effects on cartilage contact stresses during a gait cycle

The cartilage surface geometry of natural human hip joint is commonly regarded as sphere. It has been widely applied in computational simulation and hip joint prosthesis design. Some new geometry models have been developed and the sphere assumption has been questioned recently. The objective of this study was to analyze joint geometry effects on cartilage contact stress distribution and investigate contact patterns during a whole gait cycle. Hip surface was reconstructed from CT data of a healthy volunteer. Three finite element (FE) models of hip joint were developed from different cartilage geometries: natural geometry, sphere and rotational ellipsoid. Loads at ten instants of gait cycle were applied to these models based on published in-vivo data. FE predictions of peak contact pressure during gait of natural hip were compared with sphere and rotational ellipsoid replaced hip joint. Contact occurs mainly in upper anterior region of both acetabulum and femur distributing along sagittal plane of human body. It moves towards inferolateral aspect as the resultant joint reaction force changes during walking for natural hip. Peak pressures at the instant with maximum contact force were 7.48 MPa, 14.97 MPa and 13.12 MPa for models with natural hip surface, sphere replaced and rotational ellipsoid replaced surface respectively. During the whole gait cycle, contact pressure of natural hip ranked lowest in most of the instants, followed by rotational ellipsoid replaced and sphere replaced hip. The results indicate that rotational ellipsoid is more consistent with natural hip cartilage geometry than sphere during normal walking. This means rotational ellipsoid prosthesis could give a better description of physiological structure compared with standard sphere prosthesis. Therefore, rotational ellipsoid would be a better choice for prosthesis design.