Related Experiment Video
Updated: Aug 8, 2026

Nanofabrication of Gate-defined GaAs/AlGaAs Lateral Quantum Dots
Published on: November 1, 2013
Design and implementation of dynamic logic gates and R-S flip-flop using quasiperiodically driven
P R Venkatesh1, A Venkatesan1, M Lakshmanan2
1PG & Research Department of Physics, Nehru Memorial College (Autonomous), Puthanampatti, Tiruchirapalli 621 007, India.
Abstract:
We report the propagation of a square wave signal in a quasi-periodically driven Murali-Lakshmanan-Chua (QPDMLC) circuit system. It is observed that signal propagation is possible only above a certain threshold strength of the square wave or digital signal and all the values above the threshold amplitude are termed as "region of signal propagation." Then, we extend this region of signal propagation to perform various logical operations like AND/NAND/OR/NOR and hence it is also designated as the "region of logical operation." Based on this region, we propose implementing the dynamic logic gates, namely, AND/NAND/OR/NOR, which can be decided by the asymmetrical input square waves without altering the system parameters. Further, we show that a single QPDMLC system will produce simultaneously two outputs which are complementary to each other. As a result, a single QPDMLC system yields either AND as well as NAND or OR as well as NOR gates simultaneously. Then, we combine the corresponding two QPDMLC systems in a cross-coupled way and report that its dynamics mimics that of fundamental R-S flip-flop circuit. All these phenomena have been explained with analytical solutions of the circuit equations characterizing the system and finally, the results are compared with the corresponding numerical and experimental analysis.
Related Concept Videos
First-Order Circuits
One common example of a first-order circuit is the RC (resistor-capacitor) circuit. These circuits are used in relaxation oscillators such as neon lamp oscillator circuits. When voltage is...
Parallel RLC Circuits
A simplified parallel RLC circuit model with a DC input source generating a step response is employed in this context. When the switch is turned on, Kirchhoff's current law is applied, leading to a second-order differential equation.
Design Example: Underdamped Parallel RLC Circuit
Starting with a fixed...
Clamper Circuit
Within this circuit, the diode's orientation prompts the capacitor to charge up to the level of the most negative peak of the input signal. Upon reaching this state, the diode ceases to conduct,...
Switching of BJT
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are reverse-biased. The...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no current...

