A Comparison of the Effects of 20% Mannitol and 3% NaCl on Coagulation Parameters In Vitro using ROTEM: A Prospective...

The aim of the present study is to compare the effect of 20% mannitol and 3% NaCl on blood coagulation in vitro using rotational thromboelastometry (ROTEM).

Twenty-millilitre blood samples were obtained from 15 volunteers. In each group, 2 mL blood samples were collected into both polypropylene tubes and EDTA tubes for ROTEM and hemogram analysis. After sampling, blood samples were diluted with test solutions. Group C (control): Only blood, Group M (mannitol): 7% vol 20% mannitol concentration in the blood, Group hypertonic saline (HS): 7% vol 3% hypertonic saline (NaCl) in the blood, Group M/H (mannitol and hydroxyethyl starch solutions [HES]): 6% vol 20% mannitol concentration and 8% vol HES in the blood and Group HS/H (hypertonic saline and HES): 6% vol 3% hypertonic saline concentration and 8% vol HES in the blood. The following thromboelastometric parameters were measured automatically: clotting time (CT) and clot formation time (CFT) with intrinsic activation by tissue factor (InTEM), CT, CFT and maximum clot firmness (MCF) with extrinsic activation by tissue factor (ExTEM) and MCF with FibTEM.

The ExTEM CT value was found to be significantly longer in the M/H group than in the controls. The ExTEM CFT median and percentile values were: group C: 85 s (70-95 s), group M: 115 s (94-128 s), group HS: 102 s (84-114 s), group M/H: 128 s (110-144 s) and group HS/H: 118 s (107-132 s). In all the groups, FibTEM MCF values were significantly lower than the control and also there was a significant difference between groups M and HS according to FibTEM MCF values.

Whole-blood coagulation disorder induced by these solutions is mainly dependent on fibrinogen and fibrin interaction. However, 3% HS has much less negative effect on coagulation.