Related Experiment Video
Updated: Mar 3, 2026
Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere
Published on: April 30, 2018
Cold wire constant voltage anemometry to measure temperature fluctuations and its application in a thermoacoustic
Sarah Cleve1, Emmanuel Jondeau1, Philippe Blanc-Benon1
1Laboratoire de Mécanique des Fluides et d'Acoustique, UMR CNRS 5509, École Centrale de Lyon, Université de Lyon, 36 Avenue Guy de Collongue, 69134 Ecully Cedex, France.
Abstract:
The knowledge of temperature fluctuations is essential for most thermoacoustic systems. In the present paper, cold wire constant-voltage anemometry (CVA) to measure temperature fluctuations is presented. Corrections for the thermal inertia and for the end losses of the wire are applied during the post-processing. The correction for the thermal inertia of the cold wire is achieved by applying a time dependent thermal lag as proposed originally for a constant-current anemometry (CCA) system. This thermal lag is measured in parallel by a hot wire. The thermal end losses of the wires to their supports are also considered and approximate corrections are proposed. The procedure for the cold wire CVA is validated in the acoustic field of an acoustic resonator with wires of different lengths. A comparison between a CVA and a CCA measurement also confirms the CVA measurement. Furthermore, the proposed measurement procedure is applied close to the stack of a thermoacoustic refrigerator. Supposing a two-dimensional flow, the simultaneous measurement of velocity and temperature fluctuations is possible. This allows a detailed examination of the acoustic field close to the stack, including the study of the correlation between temperature and velocity.
Related Concept Videos
01:14Temperature Measurement Sites
Oral: When assessing oral temperature, the thermometer tip should be placed under the tongue in the posterior sublingual pocket. It offers accurate readings and can be...
01:14Assessing Body Temperature - Tympanic membrane
Step 1: Begin by practicing good hand hygiene to prevent the transmission of microorganisms.
Step 2: Turn on the thermometer and wait until the ready sign appears on the screen to ensure accurate measurement.
Step 3: Slide the probe cover in place to prevent cross-contamination.
Step 4: Instruct the patient to tilt their head to the side for comfort and check for cerumen...
01:13Equipments Used to Measure Body Temperature
Glass-bulb Thermometer:
Glass-bulb thermometers are hollow glass tubes with a bulb tip containing liquid such as ethanol or mercury. Historically, glass bulb mercury thermometers were the standard device to measure body temperature. Today, mercury thermometers are prohibited in many countries due to the hazardous effects of mercury and the risk of exposure if the glass bulb breaks. In general,...
01:27Thermal expansion and Thermal stress: Problem Solving
To solve the problem, first, identify the known and unknown quantities. The initial length (L) of the bridge is 1275 m, the coefficient of linear expansion (α) for steel is 12 x 10-6/°C, and the change in temperature (ΔT) is 55...
01:19Assessing Body Temperature - Temporal Artery
Step 1: Perform hand hygiene and don a fresh pair of gloves to prevent cross-infection and ensure patient safety.
Step 2: Explain the procedure to the patient to establish trust. Clear communication establishes trust with the patient, ensures they understand what to expect, promotes cooperation, and enhances comfort during the procedure.
Step 3: Assess the patient's...
01:24Galvanometer
The galvanometer consists of two concave-shaped permanent magnets, providing a uniform radial magnetic field in the annular region. In the center, a pivoted coil of fine copper wire is placed in the uniform...