Related Experiment Video

Updated: Mar 3, 2026

Generation and Coherent Control of Pulsed Quantum Frequency Combs
06:42

Generation and Coherent Control of Pulsed Quantum Frequency Combs

Published on: June 8, 2018

9.8K

Phase matching of noncollinear sum and difference frequency high harmonic generation above and below the critical

Jennifer L Ellis, Kevin M Dorney, Charles G Durfee

    Optics Express
    |May 5, 2017
    PubMed

    More Related Videos

    Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source12:19

    Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source

    Published on: April 4, 2017

    8.9K
    Direct Imaging of Laser-driven Ultrafast Molecular Rotation10:52

    Direct Imaging of Laser-driven Ultrafast Molecular Rotation

    Published on: February 4, 2017

    10.3K

    Related Concept Videos

    Double Resonance Techniques: Overview01:12

    Double Resonance Techniques: Overview

    Double resonance techniques in Nuclear Magnetic Resonance (NMR) spectroscopy involve the simultaneous application of two different frequencies or radiofrequency pulses to manipulate and observe two distinct nuclear spins. One important application of double resonance is spin decoupling, which selectively suppresses coupling with one type of nucleus while observing the NMR signal from another nucleus, simplifying the spectrum and enhancing resolution.
    Spin decoupling is usually achieved by...
    823
    Mass Analyzers: Common Types01:19

    Mass Analyzers: Common Types

    The quadrupole mass analyzer consists of four cylindrical metal rods arranged in a diamond carrying a DC voltage and a radio-frequency AC voltage. The motion of ions through the quadrupole depends on the field strength, causing only ions of a certain m/z to resonate successfully and strike the detector at a given field strength. Though the transmission rate for these analyzers is high, the exact elemental composition of the sample is not determined because of low resolution; however, they are...
    1.7K
    ¹³C NMR: ¹H–¹³C Decoupling01:04

    ¹³C NMR: ¹H–¹³C Decoupling

    The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
    A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
    1.9K
    ¹H NMR: Interpreting Distorted and Overlapping Signals01:02

    ¹H NMR: Interpreting Distorted and Overlapping Signals

    Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
    As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
    1.6K
    ¹H NMR Signal Multiplicity: Splitting Patterns01:13

    ¹H NMR Signal Multiplicity: Splitting Patterns

    When protons A and X are coupled, their nuclear spin energy levels are slightly modified. This is because the energy required to excite proton A to a spin state parallel to proton X is slightly different from the energy required for it to become anti-parallel to spin X. Consequently, there are two possible excitation frequencies for A (A1 and A2), depending on the spin state of X, and vice versa. The mutual nature of coupling implies that the difference between frequencies A1 and A2, indicated...
    7.0K
    Interference: Path Lengths01:10

    Interference: Path Lengths

    Consider two sources of sound, that may or may not be in phase, emitting waves at a single frequency, and consider the frequencies to be the same.
    Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
    2.3K