Controlling the structure of sequence-defined poly(phosphodiester)s for optimal MS/MS reading of digital information

Digital polymers are monodisperse chains with a controlled sequence of co-monomers, defined as letters of an alphabet, and are used to store information at the molecular level. Reading such messages is hence a sequencing task that can be efficiently achieved by tandem mass spectrometry. To improve their readability, structure of sequence-controlled synthetic polymers can be optimized, based on considerations regarding their fragmentation behavior. This strategy is described here for poly(phosphodiester)s, which were synthesized as monodisperse chains with more than 100 units but exhibited extremely complex dissociation spectra. In these polymers, two repeating units that differ by a simple H/CH₃ variation were defined as the 0 and 1 bit of the ASCII code and spaced by a phosphate moiety. They were readily ionized in negative ion mode electrospray but dissociated via cleavage at all phosphate bonds upon collisional activation. Although allowing a complete sequence coverage of digital poly(phosphodiester)s, this fragmentation behavior was not efficient for macromolecules with more than 50 co-monomers, and data interpretation was very tedious. The structure of these polymers was then modified by introducing alkoxyamine linkages at appropriate location throughout the chain. A first design consisted of placing these low dissociation energy bonds between each monomeric bit: while cleavage of this sole bond greatly simplified MS/MS spectra, efficient sequencing was limited to chains with up to about 50 units. In contrast, introduction of alkoxyamine bonds between each byte (i.e. a set of eight co-monomers) was a more successful strategy. Long messages (so far, up to 8 bytes) could be read in MS³ experiments, where single-byte containing fragments released during the first activation stage were further dissociated for sequencing. The whole sequence of such byte-truncated poly(phosphodiester)s could be easily re-constructed based on a mass tagging system which permits to determine the original location of each byte in the chain. Copyright © 2017 John Wiley & Sons, Ltd.