Investigation of the push-pull effects on β-functionalized benzoporphyrins bearing an ethynylphenyl bridge

R G Waruna Jinadasa1, Michael B Thomas, Yi Hu

  • 1Department of Chemistry, University of North Texas, 1155 Union Circle, #305070, Denton, TX 76203-5017, USA. Francis.DSouza@UNT.edu hong.wang@unt.edu.

Related Concept Videos

NMR Spectroscopy of Benzene Derivatives01:37

NMR Spectroscopy of Benzene Derivatives

Simple unsubstituted benzene has six aromatic protons, all chemically equivalent. Therefore, benzene exhibits only a singlet peak at δ 7.3 ppm in the 1H NMR spectrum. The observed shift is far downfield because the aromatic ring current strongly deshields the protons. Any substitution on the benzene ring makes the aromatic protons nonequivalent, and the protons split each other. The peak is, therefore, no longer a singlet and the splitting pattern and their associated coupling...
11.7K
Directing and Steric Effects in Disubstituted Benzene Derivatives01:18

Directing and Steric Effects in Disubstituted Benzene Derivatives

When disubstituted benzenes undergo electrophilic substitution, the product distribution depends on the directing effect of both substituents. When the directing effects of both substituents reinforce each other, a single product is obtained. For example, bromination of p-nitrotoluene occurs ortho to the methyl group and meta to the nitro group, which is the same position, resulting in a single product. However, if the directing effects of the two groups oppose each other, the...
4.2K
π Electron Effects on Chemical Shift: Aromatic and Antiaromatic Compounds01:14

π Electron Effects on Chemical Shift: Aromatic and Antiaromatic Compounds

In aromatic compounds, such as benzene, the circulation of (4n + 2) π-electrons sets up a diamagnetic or diatropic ring current around the perimeter of the molecule. This current induces a magnetic field that opposes the external field inside the ring and reinforces it on the outside. The protons in benzene are deshielded and exhibit high chemical shifts in the range 6.5–8.5 ppm. The shielding effect at the center of the ring is evident in complex aromatic molecules, such as...
2.0K
Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene01:13

Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene

Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.
7.7K
Reactions at the Benzylic Position: Oxidation and Reduction00:59

Reactions at the Benzylic Position: Oxidation and Reduction

The benzylic position describes the position of a carbon atom attached directly to a benzene ring. Benzene by itself does not undergo oxidation. In contrast, the benzylic carbon is quite reactive in the presence of strong oxidizing agents such as KMnO4 or H2CrO4. Therefore, alkylbenzenes are readily oxidized to benzoic acid, irrespective of the type of alkyl groups.
5.3K
Electrophilic Aromatic Substitution: Chlorination and Bromination of Benzene01:15

Electrophilic Aromatic Substitution: Chlorination and Bromination of Benzene

Chlorination and bromination are important classes of electrophilic aromatic substitutions, where benzene reacts with chlorine or bromine in the presence of a Lewis acid catalyst to give halogenated substitution products. A Lewis acid such as aluminium chloride or ferric chloride catalyzes the chlorination, and ferric bromide catalyzes the bromination reactions. During the bromination of alkenes, bromine polarizes and becomes electrophilic. However, in the bromination of benzene, the bromine...
12.1K