Related Experiment Video
Updated: Mar 2, 2026

Synthesis of Graphene Nanofluids with Controllable Flake Size Distributions
Published on: July 17, 2019
Heteroaggregation of Graphene Oxide with Nanometer- and Micrometer-Sized Hematite Colloids: Influence on Nanohybrid
Yiping Feng1,2,3, Xitong Liu1, Khanh An Huynh4
1Department of Environmental Health and Engineering, Johns Hopkins University , Baltimore, Maryland 21218-2686, United States.
Abstract:
Heteroaggregation of graphene oxide (GO) with nanometer- and micrometer-sized hematite colloids, which are naturally present in aquatic systems, is investigated in this study. The heteroaggregation rates between GO and hematite nanoparticles (HemNPs) were quantified by dynamic light scattering, while the heteroaggregation between GO and micrometer-sized hematite particles (HemMPs) was examined through batch adsorption and sedimentation experiments. The heteroaggregation rates of GO with HemNPs first increased and then decreased with increasing GO/HemNP mass concentration ratios. The conformation of GO-HemNP heteroaggregates at different GO/HemNP mass concentration ratios was observed through transmission electron microscopy imaging. Initially, GO underwent heteroaggregation with HemNPs through electrostatic attraction to form primary heteroaggregates, which were further bridged by GO to form bigger clusters. At high GO/HemNP mass concentration ratios where GO outnumbered HemNPs, heteroaggregation resulted in the formation of stable GO-HemNP nanohybrids that have a critical coagulation concentration of 308 mM NaCl at pH 5.2. In the case of HemMPs, GO adsorbed readily on the microparticles and, at an optimal GO/HemMP ratio of ∼0.002, the sedimentation of HemMPs was the fastest, most likely because of the formation of "electrostatic patches" leading to favorable aggregation of the microparticles.
Related Concept Videos
Colloidal precipitates
Coagulation
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
The Colloidal State

