Related Experiment Video
Updated: Mar 2, 2026

Influence of Step-Width Manipulation on Running Biomechanics
Published on: February 28, 2025
Changes in biomechanics of skiing at maximal velocity caused by simulated 20-km skiing race using V2 skating
O Ohtonen1, S J Lindinger2, C Göpfert1,2
1Neuromuscular Research Center, Faculty of Sport and Health Sciences, University of Jyväskylä, Vuokatti, Finland.
Abstract:
This study investigated how the fatigue caused by a 20-km simulated skating cross-country skiing race on snow affects the final spurt performance from a biomechanical perspective. Subjects performed a 100-m maximal skiing trial before and at the end of the simulated race. Cycle characteristics, ground reaction forces from skis and poles, and muscle activity from eight muscles were recorded during each trial. Results showed that subjects were in a fatigued state after the simulated race manifested by 11.6% lower skiing speed (P<.01). The lower skiing speed was related to an 8.0% decrease in cycle rate (P<.01), whereas cycle length was slightly decreased (tendency). In temporal patterns, relative kick time was increased (10.9%, P<.01) while relative poling time was slightly decreased (tendency). Vertical ski force production decreased by 8.3% while pole force production decreased by 26.0% (both, P<.01). Muscle activation was generally decreased in upper (39.2%) and lower body (30.7%) (both, P<.01). Together these findings show different responses to fatigue in the upper and lower body. In ski forces, fatigue was observed via longer force production times while force production levels decreased only slightly. Pole forces showed equal force production times in the fatigued state while force production level decreased threefold compared to the ski forces.
More Related Videos
06:35Using Gold-standard Gait Analysis Methods to Assess Experience Effects on Lower-limb Mechanics During Moderate High-heeled Jogging and Running
Published on: September 14, 2017
06:52An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
Related Concept Videos
Collisions in Multiple Dimensions: Problem Solving
A small car of mass 1,200 kg traveling east at 60 km/h collides at an intersection with a truck of mass 3,000 kg traveling due north at 40 km/h. The two vehicles are locked together. What is the...
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...